Loading ...
Loading ...
Loading ...
Version 3/15 - Page 8
See the previous page with FIGURE 5, and
FIGURE 6 above for reference. When using
the IBDD600-B
internal blower installed on
the front of the appliance use 6" Round
ducting. Holes for ducting are shown on
FIGURE 5, 6:(A) to the left or right (B)
downwards,
(C) to the rear. If the blower is being installed
to the rear of the appliance, a cut-out must be
made in the rear of the cabinet or wall where
it will be mounted and the appropriate
clearances must be maintained behind the
cabinet.
See FIGURE 5, (D) Feed the power cord
and control cable downwards or to the rear
when using an remote blower.
See FIGURE 5 (E) When using the remote
blower, install 10" ducting to the
rear. If installing the exhaust ducting to the
front, appropriate clearances must be
maintained in the cabinet.
INSTALLATION NOTES
– The specied dimensions minimum
cut-out dimensions must be observed.
– If an oven or stove is installed before
the ventilation system, read the associated
installation instructions. Note all installation
dimensions and guidelines regarding
ventilation systems.
– Be aware of kitchen cabinets, back
splashes and/or racks in the area of the
ventilation system and the cooktop. Ensure
that the area where the vent rises is free of
obstacles.
– Make sure that any required minimum
distance between the front edge of the
countertop and the front edge of the cooktop
is maintained.
– If there is a cabinet drawer in the way, it
must be shortened or removed. The front
panel of the drawer could also be installed to
permanently cover the drawer cut-out.
FIGURE 6
PRODUCT DIMENSIONS
Loading ...
Loading ...
Loading ...