M2-65B User Manual

Loading ...

Mounting (M2-TS ONLY)

Flush Mount Option

1. Determine where the tweeter will be mounted. Ensure

an area large enough for the tweeter to mount evenly. Be

sure that the mounting location is deep enough for the

tweeter to fit; if mounting in a door, operate all functions

(windows, locks, etc.) through their entire operating

range to ensure there is no obstruction.

2. Mark the location for the mounting hole. Drill the hole

with a standard 1.75 inch (45mm) hole saw.

3. With a single center screw secure the inner cup from the

front of the door panel to the outer cup from back of the

door panel. Tighten the screw until balanced pressure is

applied to both faces of the mounting surface.

4. Feed the speaker wires through the cutout. Be sure to

observe proper polarity when connecting the wires. The

speaker’s lead wires are indicated with a WHITE wire “+”

and a BLACK wire “-”.

5. Simply snap the tweeter into place and secure with

a snap-on trim ring. Removal is easy if needed. The

protective grille on the tweeter is non-removable and an

integral part of the design.

Optional Horn Loading Mounting

1. Determine where the tweeter will be mounted. Ensure

an area large enough for the speaker to mount evenly. Be

sure that the mounting location is deep enough for the

speaker to fit; if mounting in a door, operate all functions

(windows, locks, etc.) through their entire operating

range to ensure there is no obstruction.

2. Mark the location for the mounting hole.

3. Cut or use a hole saw to drill a 3-5/8” (91mm) hole for the

flange to fit.

4. Once you have the hole cut, insert the flange and mark

the locations for the mounting screws. Predrill your

mounting screw holes.

5. Assemble the horn flange, o-ring, tweeter and retaining

ring together. Pay close attention to the alignment tab on

both the tweeter and flange. These need to be lined up

for proper tweeter orientation in the flange.

6. Feed the speaker wires through the cutout. Be sure to

observe proper polarity when connecting the wires. The

speaker’s lead wires are indicated with a WHITE wire “+”

and a BLACK wire “-”.

7. Secure the flange with the included stainless steel

mounting hardware.

Flush Mount Clamp

Use tip of small ﬂat screwdriver to

remove tweeter

Panel

Optional Horn Loading Mounting Flange

Flange

O-ring

Tweeter

Retainer