Loading ...
Loading ...
Loading ...
Page 5 • JL Audio, Inc., 2019 Continued on Next Page
STEP 16
Align the forward slot in the Bracket with the
threaded insert in the side of the enclosure.
Slide a 3/8” Split Lock Washer and a 3/8” Flat
Washer over each of two 3/8 - 16 x 1” Hex Head
Bolts, pass an assembly through the slot in the
Bracket, into the threaded insert, and hand
tighten.
Repeat for the opposite side.
STEP 15
Carefully place the Stealthbox into the vehicle.
Attach speaker cable to the terminal cup on
the back of the enclosure, and position the
enclosure between the two Brackets, as shown.
STEP 14
Align the two slots on the Bracket with the
factory holes on the inside of an outer seat
support frame, as shown. Slide an M6 Split
Lock Washer and an M6 Oversized 18mm Flat
Washer over each of two M6 - 1 x 20mm Hex
Head Screw, pass an assembly through each
slot in the Bracket, thread into a factory hole,
and hand tighten.
Repeat for the opposite side.
STEP 13
Carefully unclip and remove the outer seat
bracket trim panel on the driver’s side.
Repeat Steps 12-13 for the opposite side.
STEP 12
Carefully unclip and remove the driver’s side
rear door sill panel.
STE P 11
Repeat Steps 6-9 for the passenger side rear
seat, then remove the seat from the vehicle.
STEP 10
Using a T50 Torx socket and wrench, remove
the factory seat belt bolt from the floor behind
the passenger side seat.
STEP 9
Reach over the center console, behind rear
seat back, and pull the indicated seat release
loop to unhook the latch and release the seat.
Carefully remove the seat from the vehicle.
SB-D-5GRAMCCR/10TW3 INSTR_SKU# 011542
Loading ...