8732301 User Manual

Loading ...

Page 11

NOTE:Whenbatteryisunderlowvoltage,thelockwillgivethe(LowBatteryWarning:Beepsand

LEDashesredfor5seconds).Duringthistimeyourlockcanstillwork.Howeveroncethevoltage

islowerthan4.3V(calledSuper-LowVoltage),theoperationofthelockingandunlockingwillnot

work,usermustreplacebatteriesimmediately.

Unlock/Validprogramming: 1longbeepandLEDilluminatesgreen

Lock: 2shortbeepsandLEDilluminatesred

InvalidProgramming: 2shortbeepsandLEDashesredtwice

LowVoltage: Beepsfor5seconds

(7/9timesdependsonoperationisunlock/lock)

SuperLowVoltage: 4shortbeepsandLEDashesredfourtimes

4Incorrectcodeentryattempts: 2shortbeepsandLEDilluminatesredeachattempt

Poweron: 1longbeepand1shortbeepandLEDilluminatesgreen

ChipReset: 1longbeepand1shortbeepandLEDilluminatesgreen

(mayoccurseveraltimesoronceinawhile)

LockError: 3longbeepsLEDashesredthreetimes

RepeatoperationafterLockError: 2shortbeepsthreetimesLEDashesredsixtimes

CONSUMERFRIENDLYMESSAGEGUIDE

INSTALLATIONTROUBLESHOOTING

Issue Solution

Lockwillnotfunction

electronically

• Check that all batteries are fresh high quality

Alkaline Batteries

• Check for proper polarity (+ -) of all batteries

• Check that the Control Wire is attached to the

Interior Assembly

Latch is sticking.

Installation screws of the lock may be too tight and have to be

loosened

• Remove Interior Assembly

• Slightly loosen the Mounting Plate Screws

• Lock and unlock using the Key

• Reattach Control Wire and Interior Assembly

NOTE: If you only press the for more than 3 seconds but

do not input

, the system will remain in Vacation Mode.

Loading ...

User Manual - Page 13