Loading ...
Loading ...
Loading ...
19
NOTE: Pre-tinned wires should not be used when connecting to
the terminal block. Ensure black is aligned with black and white is
aligned with white in the terminal block.
Strip insulation and wrap wire
23. Secure cord or wire in strain relief
Tighten strain relief screws to secure cord.
24. Reinstall terminal box cover and wires
Place wires inside terminal box. Replace the cover by inserting
the hooks of the terminal cover into the slots in the oor of the
terminal box and sliding the cover tight against the back wall
where wires come in. Make sure wires are tucked inside the box
and not pinched by the cover.
Put the terminal box back on the crossbar and push to the right
so terminal box snaps into the plastic side member.
NOTES:
■ Do not plug cord into an outlet until instructed to do so.
■ Once the terminal box has been remounted on the dishwasher,
tuck any excess length or slack over nearby components to
help keep them off the oor.
■ Route cord out the rear of the dishwasher so that it does not
touch dishwasher motor or lower part of dishwasher tub.
■ A maximum of 2 power cord supply conductors (12 AWG
largest size) plus 1 grounding conductor are permitted in the
terminal box.
IMPORTANT: No additional connections other than dishwasher
power connection are to be made inside the dishwasher terminal
box.
INSTALL DOOR HANDLE
(ON SOME MODELS)
25. Install door handle
IMPORTANT: Do not scratch the front panel during this
procedure. If door panel has a protective lm, peel lm back past
the point of the handle studs before installing handle. Handle is
easiest to install while unit is on its back.
Wire wrapped two-thirds around
Wire wrapped three-quaters around
Figure: 1
Figure: 2
Figure: 3
Snug Contact
Screw Post
Contact Surface
Contact surface
The stripped wire should always
have a 2/3 to 3/4 wrap around
the screw threads
Hex key
Handle
Setscrew
(in bottom
of handle)
Mounting stud
Loading ...
Loading ...
Loading ...