Loading ...
Loading ...
Loading ...
10
Top/Upright freezer models (continued)
Refer to the side diagrams for the following steps.
1. Locate the ll tube and the round foam gasket from the ice
maker kit (the gasket may already be installed on the ll
tube). If not already done, slide the gasket over the end of the
ll tube.
Insert the ll tube through the hole in the rear of the
refrigerator with the spout facing down, and secure it with two
1/2" hex-head sheet metal screws.
Refer to the side diagrams for the following steps. You will be
working inside the freezer compartment.
1. Slide the plastic ll tube extension (See components table on
page 5) over the end of the ll tube as far as it will go (see
DETAIL A).
NOTE: The plastic ll tube extension is not required for
models with open-top ll tube.
2. Flat wiring cover: Install the wiring cover over the ll tube
with the wiring harness through the slot. Hook the tab in the
side of the wiring cover into the slot in the back cover of the
freezer, and secure the cover with the screw you removed
earlier (see DETAIL B).
Installing the ll tube/gasket
1/2" hex-head
sheet-metal
screws
Spout
Fill tube
Foam gasket
Wiring harness
Fill tube extension
(See components
table on page 5)
Fill tube
DETAIL A
Installing the ll tube extension
Reinstalling the at cover
Tab
Screw
Route harness and
ll tube through
openings
DETAIL B
Loading ...
Loading ...
Loading ...