Loading ...
Loading ...
Loading ...
ENGLISH
43 44ninjakitchen.eu
CARE & MAINTENANCE
CLEANING
Wait for all parts to cool before cleaning.
Separate all parts.
Hand-Washing
Wash the jug, lid, and tamper with warm,
soapy water. Use the included cleaning
brush to avoid direct contact with the
blades.
Dishwasher
The lid, centre cap and tamper are
dishwasher safe.
Motor Base
Press the power button to turn o the
unit, then unplug the motor base. Wipe
motor base with a clean, damp cloth.
CLEAN
A combination of heat and rapid pulses
easily removes residue from the nonstick
coating in minutes
1
Fill jug with 700ml of water and 2 small
drops of washing up liquid.
2 Place the lid on the jug and ensure it is
properly closed.
3 Press CLEAN.
4 When the program is complete, discard
the water and thoroughly rinse the jug.
TIPS FOR BEST CLEANING RESULTS:
1
Give the jug a quick rinse before running
the CLEAN program.
2
Run the CLEAN program immediately
after use.
STORING
Store the unit upright with the lid secured
on the jug.
RESETTING THE MOTOR
This unit features a unique safety system
that prevents damage to the motor by
temporarily disabling the motor if it begins
to overheat. Should this occur, follow the
reset procedure below.
1 Unplug the unit from the socket.
2 Allow the unit to cool for approximately
15 minutes before using.
IMPORTANT: Ensure that maximum
capacities are not exceeded. This is the
most typical cause of appliance overload.
ORDERING REPLACEMENT PARTS
To order additional parts and attachments,
visit ninjakitchen.eu
NOTE: DO NOT stack items on top of the
unit. Store any remaining attachments
alongside the unit or in a cabinet where they
will not be damaged or create a hazard.
NOTE:
DO NOT submerge the blender
jug. Submerging will damage the
integrated heating element.
NOTE:
DO NOT wash the blender jug
in the dishwasher. Dishwashing will
damage the integrated heating element.
ERROR MESSAGES
NOTE: DO NOT attempt to remove
the jug while the blender is running.
Wait for the blades to stop spinning
before removing the jug.
DISPLAY SCREEN MESSAGES
“Lid”
The lid is not assembled correctly. Be sure
the lid is on the jug and locked in place
before running a program.
“JAr”
The jug is properly attached to the base.
Be sure the jug is secured in the base
before selecting a program.
“---” Blinking
You are attempting to run a program
too many times in a row. For your safety,
certain programs may be run only 2
consecutive times.
ERROR MESSAGES
“E01” or “E02”
Remove and reinstall the jug. If that does not
solve the issue, contact Customer Service.
So we may better assist you, please register
your product online at
registeryourninja.com
and have the product on hand when you call.
Loading ...
Loading ...
Loading ...