Loading ...
Loading ...
Loading ...
62
EN
Spray arms
It is necessary to clean the spray arms regularly for hard water chemicals will clog the
spray arm jets and bearings. To clean the spray arms, follow the instructions below:
To remove the upper spray arm,
hold the nut in the middle and turn
the spray arm counterclockwise to
remove it.
To remove the lower spray arm, pull
out the spray arm upward.
Wash the arms in soapy and warm
water and use a soft brush to clean
the jets. Replace them after rinsing
them thoroughly.
Frost precaution
Please take frost protection measures on the dishwasher in winter. Every after washing
cycles, please operate as follows:
1. Cut off the electrical power to the dishwasher at the supply source.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain the water from the inlet pipe and water valve. (Use a pan to gather the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the ī”“lter at the bottom of the tub and use a sponge to soak up water in the
sump
After every wash
After every wash, turn off the water supply to the appliance and leave the door slightly
open so that moisture and odors are not trapped inside.
Loading ...
Loading ...
Loading ...