Loading ...
Loading ...
Loading ...
RECOMMENDATION FOR USE
- There is no point in setting maximum heating; the room temperature will not rise any quicker.
- When you air the room, stop the panel heater by putting the!!to switch to! !.!
- If you leave the room for several hours slide the switch! to! !eco position.!
Absence for:
+ Less than 2 hours, set the!!switch knob to moon!! .!
+ 2 to 24 hours, either you can lower the control dial!!by two graduations, select eco mode!
!or switch to!! !!.!
- If you have several units in a room, let them operate simultaneously. This will give you a more
uniform temperature without increasing electricity consumption.
WARNINGS
Children must not lean on the appliance. Under certain circumstances, there is a risk that its
surface may cause burns to the skin of young children. If there is any risk of this at all, install a
protection grill. This device is not intended for use by persons (including children) with physical,
sensory or mental disability, or by persons lacking experience or knowledge, unless they have
received from a person in charge of their safety adequate supervision or preliminary instructions
on how to use the device.
Care must be taken at all times to keep children from playing with the device.
Do not introduce objects or paper into the device.
Do no cover the device
Do not totally or partially block the grilles on the front or inside of the appliance, as this may cause
overheating. If the supply cord is damaged, it must be replaced by a service agent or similarly
qualified person in order to avoid a hazard (applies to all units). All work to the inside of the
appliance must be carried out by a licensed electrician.
MAINTENANCE
To maintain performances of your unit, you should clean the upper and lower grilles of the unit
about twice a year using a vacuum cleaner or a brush.
Have a professional check the inside of the unit every five years.
Dirt may collect on the grille of the unit if the atmosphere is polluted. This phenomenon is due to
the poor quality of the ambient air. In this case, it is recommended to check that the room is well
ventilated (ventilation, air inlet, etc.), and that the air is clean. The unit will not be replaced under
the guarantee because of this type of dirt.
The unit casing should be cleaned with a damp cloth, never use abrasive products.
TROUBLE SHOOTING
If the unit does not heat:
Check that the timer is in COMFORT mode
Make sure that the installation circuit breakers are switched on, or that the load shedder (if you
have one) has not switched off the unit power supply. Check the air temperature in the room.
The unit does not carry out programming orders:
Make sure that the timer is being correctly used (refer to its user’s manual) or that the Chronopass
is properly inserted in its housing and that it is operating normally and check battery life.
The unit is permanently heating:
Make sure that it is not in a draft and that the temperature setting has not been changed.
Loading ...