Loading ...
Loading ...
Loading ...
Dimplex
Millbrook House
Grange Drive
Hedge End
Southampton
Hampshire.
SO30 2DF
[c] Glen Dimplex Heating & Ventilation
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex Heating & Ventilation
Thermostat (T) - see Fig. 4
In order to maintain a certain room temperature, set the
controller to ‘max.’. Operate the appliance at full power
until the required room temperature is reached. Turn back
the thermostatic controller until the appliance switches off
with an audible “click”. This temperature will be kept almost
constant by the thermostatic control switching on and off
automatically.Please note that the appliance can only be
switched on when the thermostat setting is higher then the
room temperature.
Remote control - see Fig. 3
The maximum range of use is ~ 15metres.
Warning: It takes time for the receiver to respond to the transmitter.
Do not press the buttons more than once within two seconds for
correct operation.
Battery information - see Fig. 3
1. To activate the remote control remove the battery isolation
strip, which is used to ensure your remote control reaches
you fully charged.
2. To replace the remote control battery, turn over the remote
control, and follow the diagram embossed on the remote control
3. Only use CR2025 or CR2032 size of batteries
Discard leaking batteries
Dispose of batteries in the proper manner according to
provincial and local regulations.
Any battery may leak electrolyte if mixed with a different battery
type, if inserted incorrectly, if all the batteries are not replaced at
the same time, if disposed of in a re, or if an attempt is made
to charge a battery not intended to be recharged.
Thermal Safety Cut-out
The built-in overheat cut-out switches off the appliance
automatically in the event of a fault. Switch off the appliance
or disconnect the mains plug from the socket. After a short
cooling down phase, the appliance is ready for use again. If
the fault should occur again, see your local dealer.
Light Emitting Diode
This re is tted with LED (Light Emitting Diode) lamps. These
LED lamps are maintenance-free and should not require
replacing during the life of the product.
Tel. 0344 879 3588
Website www.dimplex.co.uk
Republic of Ireland Tel. 01 8428222
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE ATTEMPTING ANY MAINTENANCE.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use
abrasive cleaners. The glass viewing screen should be
cleaned carefully with a soft cloth. DO NOT use proprietary
glass cleaners.
To remove any accumulation of dust or uff the soft brush
attachment of a vacuum cleaner should occasionally be used
to clean the outlet grille of the fan heater.
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it should not
be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for
recycling advice in your country.
After Sales Service
Your product is guaranteed for one year from the
date of purchase.
Within this period, we undertake to repair or
exchange this product free of charge (& subject
to availability) provided it has been installed and
operated in accordance with these instructions.
Your rights under this guarantee are additional to your statutory
rights, which in turn are not affected by this guarantee.
Should you require after sales information or assistance with
this product please go to www.dimplex.co.uk where you will
nd our self help guide by clicking on “Support” or ring our
helpdesk on 0344 879 3588 (UK) or 01 842 8222 (R.O.I.) .
Spare parts are also available on the website
www.dimplex.co.uk
Please retain your receipt as proof of purchase.