Schwinn IC2 ASSEMBLY MANUAL / OWNER’S MANUAL

Loading ...

SERVICE MODE

ServiceModeletsyousettheunitsofmeasuretoeitherEnglishorMetric,seemachinestatisticsandrmwareversion

(fortechnicianuseonly).

1. When the Console is in Workout Mode or Pause Mode, push and hold down the button for 5 seconds to go into Ser-

vice Mode.

Note:TapthebuttontomovethroughtheServiceModeMenuoptions.WhentheConsoledisplayshows“dOnE”,

push and hold the button for 3 seconds to reset the workout data and go back to Workout Mode.

2. The Console display shows the Units prompt. Push and hold the button to start Units option. Push the button to

changebetween“LbS”(Englishunits)and“SI”(metricunits).

3. Push and hold the button for 3 seconds to set the units. The Console display shows the Units prompt.

4. Push the button to go to the Stats prompt. Push and hold the button to start the machine Stats option. The Console

display shows Total Distance. Push the button to change between Total Distance and Total Time.

Note:TheTotalDistancevalueisawholenumberofmiles/km(nodecimalpoint).

5. Push and hold the button for 3 seconds to go back to the Stats prompt.

6. PushthebuttontogototheFirmwareVersionprompt.Pushandholdthebuttontoseethermwareversionofthe

Console.

7. Push and hold the button for 3 seconds to go back to the Firmware Version prompt.

8. Pushthebuttontogototheexitoption.TheConsoledisplayshows“dOnE”.

To go back to Workout Mode, push and hold the button for 3 seconds. The workout data is reset.

To go through the Service Mode Menu again, tap the button. The Console display will show the Units prompt.

InServiceModeiftheConsoledoesnotreceiveanyinputinapproximately5minutes,itgoesintoSleepMode.

Loading ...

Schwinn IC2 Indoor Cycling Bike