Loading ...
Loading ...
Loading ...
Unit:mm
Step 1 :
PREPARE CUPBOARD OPENING
Step 2 :
PREPARE ELECTRICAL WIRING
This dishwasher is designed to fit to the size
shown as below.
Select a location as close to sink as possible
for easy connections to water and drain
lines.
The dishwasher should not be installed
more than 3 meters from sink for proper
drainage.
If dishwasher is to be installed in a corner, a
minimum 5cm of space is required between
the washer and an adjacent cabinet or a
wall.
CAUTION
For personal safety, remove house fuse or
open circuit breaker before installation. Do not
use an extension cord or adapter plug with this
appliance. Electrical and grounding
connections must comply with the national
electrical code/provincial and municipal code
and/or other local codes.
WARNING
Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person. Any plumbing
work required to install this appliance should
be carried out by a qualified plumber or
competent person.
INSTALLATION INSTRUCTION
1
2
3
This appliance must be supplied with
correct rating voltage and hertz as shown
on instruction manual, and connected to an
individual, properly grounded branch
circuit, protected by minimum 15 amp
circuit breaker or time delay fuse.
Wiring must be 2 wires with ground.
The power plug must be in a accessible
location adjacent to and not behind the
dishwasher and within 1.2 meters of the
dishwasher side.(See page 7 Fig.A)
The power plug must be correctly earthed,
if in doubt, have it checked by a qualified
Electrician. No other appliance should be
connected to the same plug outlet by a
double adapter or similar plug.
1
2
3
4
If bare chipboard is adjacent to or above the
dishwasher, it should be sealed with a
waterproofing paint or sealant to prevent
swelling due to steam.
5
Loading ...
Loading ...
Loading ...