Loading ...
Loading ...
Loading ...
6
En
a INPUT LEVEL knob
Turn this INPUT LEVEL knob to adjust the input level of
the signal from the
INPUT
jacks. Normally, set to MAX.
b INPUT/OUTPUT jacks
These are the analog audio inputs and outputs. Use an
RCA-type audio connection cable to connect the
output jacks of the device to the INPUT jacks on the
M-5010. When connecting a control amplifier or
preamplifier, connect the PRE OUT jacks to the
INPUT jacks.
If you connect the OUTPUT jacks of the M-5010 to
the INPUT jacks of another M-5010, the signal input
at the INPUT jacks of the M-5010 is also output from
the OUTPUT jacks (Input/Output Link Function).
c 12V TRIGGER IN/OUT jacks
Connect the 12V TRIGGER IN jack to an AV
Receiver that has a 12V TRIGGER output jack.
This jack works on between 5 to 12 volts DC.
If you want another component to be
activated/deactivated by turning on/off the AV
receiver connected to the 12V TRIGGER IN jack of
the M-5010, connect the 12V TRIGGER input jack of
that component to the 12V TRIGGER OUT jack of
the M-5010. In this state, the 12V TRIGGER is output
when the M-5010 is turned on.
Devices can be connected in series using these jacks.
Use 1/8-inch (3.5mm) monaural-type mini-jack
connectors or the supplied stereo mini-plug cable.
The tip polarity of the connector is positive.
d SPEAKERS terminals
Connect Speakers.
e TRIGGER selector
Set this TRIGGER switch before turning on the
M-5010.
To turn on the M-5010 with the signal input from the
12V TRIGGER IN jack, set the TRIGGER switch to
12V TRIGGER.
To turn on the M-5010 with the signal input from the
INPUT jack, set the TRIGGER switch to AUDIO
(Auto Power On Function). If you do not use Auto
Power On Function, set the TRIGGER switch to OFF.
f AUTO STANDBY selector
Enables or disables the Auto standby function.
g SPEAKER IMPEDANCE selector
Switches the speaker impedance to 4 or 8 .
h POWER CORD
Rear Panel
12V
TRIGGER
TRIGGER
12V
TRIGGER
AUDIO
OFF
INPUT
LEVEL
MIN
MAX
IN
OUT
83
456712
Loading ...
Loading ...
Loading ...