Loading ...
Loading ...
Loading ...
13
Installation
Door removal
Electric Shock Hazard
Disconnect electrical supply to refrigerator before
installing. Failure to do so could result in death or
serious injury.
If your access door is too narrow for the
refrigerator to pass through, remove the
refrigerator door and pass the refrigerator laterally.
Remove the lower cover by lifting upward and then pull up the feed water tube
while pressing area shown in the figure to the right.
Remove lower
cover and
then feed water
tube
Remove the
freezer
compartment
door
Remove the
refrigerator
door
1) Removing the hinge cover by loosening
the screws. Separate all connection wires
leaving the earth wire till last.
2) Remove the keeper by rotating it counter
clockwise () and then lifting the upper
hinge up ().
3) Remove the freezer compartment door by
lifting it upward. This time, the door should
be lifted enough for the feed water pipe tube
to be completely pulled out.
1) Loosen the hinge cover screws and
remove the cover. Remove connection
wire, if any, leaving the earth wire till
last.
2) Remove keeper by rotating it clockwise
() and then remove the upper hinge
by lifting it up ( ).
3) Remove the refrigerator compartment
door by lifting it up.
•
If a tube end is deformed or abraded, cut the part away.
NOTE
•
When removing the upper hinge, be careful that the door does not fall forwards .
NOTE
•
Once the door has been removed, lay it down carefully inside paying careful
attention not to damage water feed pipe.
NOTE
Lower cover
Lower hinge
Lower hinge
Keeper
Feed water tube
Connection
wires
Hinge
cover
Upper hinge
Keeper
Upper hinge
Ground Line
Upper hinge
Connection
wires
WARNING
Loading ...
Loading ...
Loading ...