Loading ...
Loading ...
Loading ...
www.kegco.com 5 1-888-980-4810
Installation Instructions
BEFORE USE:
Remove the exterior and interior packaging.
Move the unit as close to the final location as possible before removing the wooden pallet.
To remove the pallet, use a screwdriver to remove the screws from the L-bracket connecting the unit to the
pallet. Unscrew all base rail anchor brackets and place the pallet to the side. Then, carefully upright the unit.
Before connecting the unit to the power source, let it stand upright for approximately 24 hours. This will reduce
the possibility of a malfunction in the cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
This appliance is designed for freestanding use. A space of at least 3” should be allowed between the
surrounding walls and the cabinet wall for air circulation.
Place the unit on a flat, solid floor that is strong enough to support it when it is fully loaded
When moving your refrigerator, please do not incline it more than 45 degrees.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the unit to perform improperly. Do not mount the draft tower remotely, as the
exposed beer line will not be refrigerated, causing foam.
Install the unit in a dry place to prevent rust from forming on the compartment body, which may affect the
electrical insulation.
Plug the kegerator into an exclusive, properly installed and grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or electrical grounding should be directed to a certified electrician or authorized products service center.
After plugging the appliance into a wall outlet, allow the unit to cool down for 3 to 4 hours before installing a
keg in the appliance.
SEALING THE CABINET TO THE FLOOR:
This method may be used when sanitation codes require sealing the kegerator to the floor.
1. Position the Cabinet
Allow 1 inch between the wall and the rear to assure proper ventilation
2. Level Cabinet
The cabinet should be level side to side and front to back. Place a carpenter’s level in the interior cabinet floor
in four places:
The inside floor of the unit near the door. Level should be parallel to the front of the cabinet.
The inside rear of the unit near the door. Level should be parallel to the back of the cabinet.
The inside left and right sides. Level should be parallel to the depth of the cooler.
3. Apply Sealant
Draw an outline on the base of the floor
Raise and block the front sides of the cabinet
Apply a bead of NSF approved sealant to the floor half an inch inside of your drawn outline. The bead
must be heavy enough to seal the entire cabinet surface when it is set down on the sealant.
Raise and block the rear of the cabinet.
Apply sealant on the floor as outline above.
Examine to see that the cabinet is sealed to the floor around the entire perimeter.
Loading ...
Loading ...
Loading ...