Loading ...
Loading ...
Loading ...
g. A
g. B
g. C
5
ASSEMBLY INSTRUCTIONS
1. Place storage case
on a at surface with
Cuisinart logo facing
up. Open lid by lifting
interlock tab between
handles. Lift top to open.
2. Carefully remove
blades from storage
case. Before rst use,
separate the blades
and wash them in hot,
soapy water or in the
dishwasher. CAUTION:
BLADES ARE SHARP.
HANDLE WITH CARE. Dry thoroughly.
3. Attach the blades by inserting the rivet on one
blade into the keyhole of the other blade.
OPERATING INSTRUCTIONS
1. Be sure to fully charge
your electric knife for 4
hours prior to rst use.
2. The blades must be
assembled before
tting into knife.
Caution: Always engage
safety switch before
handling blades or blade
guide.
Holding the blades with
the serrated edge away
from you, insert blades until you hear a click.
The blades may not line up evenly when properly
inserted.
Caution: The blades are very sharp; be careful
when handling them.
3. Slide the safety switch to the unlock position
and press/hold the thumb control to activate
the electric knife.
4. Press and hold the thumb control as you cut,
keeping the blade straight so thickness of
slices is consistent.
Caution: NEVER place your hand on top of the
blade to support it while operating the knife as
the blades are designed to move back and forth.
5. Blade automatically stops when On/Off control
is released.
HOW TO USE THE
THICKNESS GUIDE
The adjustable thickness guide is to be used
as an optional tool to ensure slices remain
consistent and uniform. Use of the thickness
guide is not required to operate the knife and can
be stored in the provided carrying/storage case
until necessary.
Attaching/Adjusting the Thickness Guide
To attach the thickness guide to your knife,
rst ensure the safety switch is in the locked
position. Looking at
the bottom of the unit,
attach the thickness
guide by inserting
and tightening the
provided thumb
screw once you
have selected the
desired thickness
(markings are found
on the underside of
thickness guide, see
g. A and B).
To adjust the
thickness guide,
loosen thumb screw
and slide guide until
the desired marking is
lined up with the pin
(see g. C). Tighten thumb screw to ensure
the guide is securely in place prior to use.
During extended periods of use, check every so
often to make sure thumb screw does not require
re-tightening.
Loading ...
Loading ...
Loading ...