Loading ...
Loading ...
Loading ...
13
ENG
ENGLISH
ASSEMBLING AND PREPARING
Using the Kensington locking
device
The connector for the Kensington lock is located
on the rear of the monitor.
For more information on installation and usage,
refer to the Kensington lock user manual or visit
the website at http://www.kensington.com.
Connect the monitor to the table with the Kensing-
ton lock cable.
y
Using the Kensington lock is optional. The
accessories can be purchased at your local
electronics store.
NOTE
y
Once the pin is removed, it is not necessary
to re-insert it to adjust the height.
Adjusting the stand height
1
Place the monitor mounted on the stand base
in an upright position.
2
Remove the
tape
attached at the bottom rear
of the
stand body,
then pull out the
locking
pin
.
3
The height can be adjusted up to
110 mm
.
The height can be adjusted up to
130 mm
.
Tape
Tape
Locking Pin
Locking Pin
Stand Body
Stand Body
CAUTION
110.0mm
130.0mm
y
Do not put your finger be-
tween the screen and the
base (chassis) when adjust-
ing the screen's height.
WARNING
23MB35PH
23MB35PH
24MB35PH
23MB35PH
24MB35PH
24MB35PH 27MB35PH
27MB35PH
27MB35PH
Loading ...
Loading ...
Loading ...