Loading ...
Loading ...
Loading ...
PRODUCT FEATURES
• Built-in or free-standing installation.
• Temperature can be set from 36°F to 43°F (2°C
to 6°C) and can be displayed in either
Fahrenheit or Celsius.
• Dynamic compressor type cooling to ensure
interior air circulation with even distribution of
temperature.
• Soft White LED Interior Light with ON/OFF
switch making it easier to view your content
without opening the door.
• Open-door and malfunction warning system.
• Sabbath mode will allow the lights to remain off
during certain religious observances.
• Temperature memory function - If power is
interrupted (power surge, breaker switch, etc.)
and then powered up again, the unit will operate
at the last temperature set-point.
• Automatic defrosting with defrost water
evaporation.
• Reversible tempered double pane light gray
glass door creates an attractive display with little
condensation and minimal noise.
• Black coated matte steel outer frame and black
plastic interior liner.
• Stainless steel-framed glass door with stainless
steel handle.
• Roll-out and adjustable shelves allow for
maximum convenience and flexibility to
accommodate various sized bottles.
• Refrigerant and foaming insulation glass are all
CFC, HCFC and HFC free, making them
environmentally friendly.
INSTALLATION
BEFORE USING YOUR APPLIANCE
• Remove all exterior and interior packing. Clean
the interior surface with lukewarm water using a
soft cloth. The unit may have residual odors at
first; they will disappear as the unit cools.
• IMPORTANT: Before connecting the unit to the
power source, let it stand upright for
approximately 24 hours. This will reduce the
possibility of a malfunction in the cooling system
caused by handling during transportation.
• The door on this appliance can be opened from
either the left or the right side. The unit is
delivered with the door opening on the right side.
Should you wish to open the door from the left,
follow the instructions in the section titled
Reversing the door Hinge.
• Install the handle on the door.
INSTALLATION OF YOUR APPLIANCE
• The appliances are designed to be built-in or
free standing.
• CAUTION: This appliance is designed for
storing and cooling beverages. Do not store
perishable food, medicine or other medical
products in this unit.
• Place your appliance on a floor that is strong
enough to support it when it is fully loaded. To
level your unit, adjust the front adjustable legs at
the bottom of the unit.
• For free-standing installation, 5 inches (127mm)
of space between the back and sides of the unit
are suggested, which allows the proper air
circulation to cool the compressor and
condenser for energy saving. Even for built-in
installation, you must keep ¼” (5mm) space on
each side and at the top to ensure proper
service access and ventilation. The air vent at
the front of the appliance must never be
covered or blocked in any way!
• Install the unit away from direct sunlight and
sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and
heat sources may increase electrical
consumption. Extreme cold ambient
temperatures may also cause the unit not to
perform properly.
• Avoid installing the unit in damp areas such as
garages and damp basements.
• Plug the unit into its own, easily accessible and
properly grounded wall outlet. Do not under any
circumstances cut or remove the third (ground)
prong from the power cord. Any questions
concerning power and/or grounding should be
directed towards a qualified electrician or an
authorized products service center.
• The appliance must be installed to all electrical,
plumbing, water and drain connections in
accordance with state and local codes.
• IMPORTANT: HIGH HUMID CLIMATE. During
periods of high humidity, some condensation
may appear on the outside surfaces of the glass
5
Loading ...
Loading ...
Loading ...