Life Fitness T3-XX00-0103 Treadmill

OWNER'S MANUAL - Page 17

For T3-XX00-0103.

PDF File Manual, 26 pages, Read Online | Download pdf file

T3-XX00-0103 photo
Loading ...
Loading ...
Loading ...
$&$) *  "$ "$ ##" &"&'
D. Start: Causes the belt to begin moving at .5 mph and 0% elevation.
E. Stop: Causes the belt to slow to a gradual stop. One push pauses the workout, two pushes displays workout infor-
mation, and three pushes reset the workout.
F. Incline Arrows: Change the belt’s incline gradually, increasing (up arrow) or decreasing (down arrow) the incline by
.5% each time the user presses an arrow. Maximum incline is 15%.
G. Speed Arrows: Change the belt’s speed gradually, increasing (up arrow) or decreasing (down arrow) the speed by .1
mph each time the user presses an arrow. Maximum speed is 12 mph (19 km/h).
H. Low/Med/High: Changes the belt’s incline immediately to a preset value. Initially these buttons are set to change the
incline to 1.5% (Low), 3% (Mid) and 5% (High). However, the user can set these buttons to new values by first
changing the belt’s incline to the desired new value, then holding down the button the new value will be assigned to
until the treadmill beeps.
I. Walk/Jog/Run: Changes the belt’s speed immediately to a preset value. Initially these buttons are set to change the
speed to 2 mph (Walk), 4 mph (Jog) and 6 mph (Run). However, the user can set these buttons to new values by
first changing the belt’s speed to the desired new value, then holding down the button the new value will be
assigned to until the treadmill beeps.
J. E-Stop Magnet: This circular magnet connects to the E-Stop Lanyard, which must be clipped to the user’s clothing
when the treadmill is in use. Pulling the lanyard so that it comes free of the magnet will stop the treadmill’s striding
belt; this serves as a safety feature, stopping the belt should the user stumble or fall. Replacing the magnet will
show the Workout Summary data.
Note: Removing the E-Stop magnet stops the walking belt and incline motor, but all parts are still electrically ener-
gized. In case of electrically caused errors, remove the power cord from the electrical outlet.
15
Loading ...
Loading ...
Loading ...