Loading ...
Loading ...
Loading ...
22
TROUBLE SHOOTING
In case of malfunction, you can solve many common
problems easily.
Your Refrigerator will not operate, check if:
-The power supply cord is unplugged.
-The thermostat knob is set to OFF position.
The light doesn’t work, check if:
-The power supply cord is unplugged.
-A household fuse or circuit breaker has tripped.
-A light bulb is loose in the socket.
-A light bulb has burned out.
Food in the refrigerator compartment freezing,
check if:
-The thermostat knob is set too cold
-The position of food stored touches the refrigerator
back wall.
Food in the refrigerator compartment is not cold,
check if:
-The door is opened too often or not closed properly.
-A large amount of food has just been added to the
refrigerator or refrigerator compartment.
-The position of the thermostat knob is adjusted too
low.
Melted frost leak inside compartment or on floor,
check if:
-The drain pipe is blocked.
-Water tray is in the correct place
The refrigerator seems to make unusual noise,
check if:
-The refrigerator is leveled on the floor.
-The cabinet of the refrigerator touches the wall.
-The water tray is in the correct place.
There is interior moisture build –up, check if:
-The air vents are blocked in the refrigerator.
-The door is opened too often
-The room is humid.
-The food is not packaged correctly
-The control is not set correctly according to the
surrounding conditions.
The doors will not close completely, check if:
-The shelves are out of position
-The gaskets are dirty
-The fridge is not level
REVERSING THE DOOR SWING
1- Disassemble the screws
behind the fixed roof with
cross-slot screwdriver and
remove the cover from the
refrigerator.
2- Remove the screws
fixed the hinge with
cross-slot screwdriver.
3- Move the top hinge to
the opposite side.
4- Move the block to the
opposite side.
5- Disassemble the screws
on the bottom hinge and
fix it on the opposite side.
note：the refrigerator
incline angle less 45°
6- Remove the screws
fixed the hinge with
cross-slot screwdriver,
take off the door, the
sleeve and the hinge.
7- Remove the screws fixed the hinge with cross-slot
screwdriver，move the lock to the opposite side.
8- The door turned 180
degrees, and move the
sleeve and the hinge to the
opposite side.
9- Set the door on the right position, fix the hinge and
then the roof cover.
Ensure the appliance is
unplugged and empty.
Adjust the two leveling feet to
their highest position.
We recommend you have
someone to assist you.
NOTE:
To take the door off it is necessary to tilt the
appliance backward.
You should rest the Appliance on something solid e.g.
a chair just below the top panel.
Do not lay the Appliance completely flat as this may
damage the coolant system.
Loading ...
Loading ...
Loading ...