Loading ...
Loading ...
Loading ...
6 49-3000198-1
A
B
C
Power
Press to “wake up” the display. If the display is active, press to put the dryer into idle mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Start and Pause
Press Start to begin the cycle. NOTE: The door must be closed for the dryer to start the cycle. Pressing Start
again will pause the cycle, the Start light will blink and “Pause” will display.
To continue the cycle, press Start again.
Display and Status Lights
The display shows the approximate time remaining until the end of the cycle.
In addition, this display will show the dryer status:
Features and appearance will vary.
Getting started
USING THE DRYER
A CE
B F D H I
G
H
Controls
Drying
Cooling
Pause
Damp
Sensing
Cycle Status:
On Damp
Less Dry
Dry
Lint Filter
Clean
More Dry
No Heat
Low
Medium Check Vent
High
Est. Time
Remaining
20 min.
40 min.
60 min.
90 min.
10 min.
20 min.
A CE
B D F
G
HE HI
Pause
(on some models)
The Start/Pause light will flash and the message “Pause” will show in the display when
the dryer’s cycle is paused. The cycle may be re-started by pressing the Start button.
WiFi
(on some models)
Will allow your appliance to communicate with your smartphone for remote appliance
monitoring control and notifications.
Controls
The dryer is locked - will blink once if you press any button or turn the cycle knob.
Sensing Indicates the dryer is sensing the level of dampness to determine estimated cycle time
remaining.
Clean Lint Filter The Clean Lint Filter light will stay on for 15 seconds after the cycle stops.
Check Vent
(on some models)
The Check Vent light indicates an issue has been found due to reduced airflow from a possible
blocked or restricted vent. Checking and/or cleaning the vent system is recommended. See the,
“Check Vent” light is on in the Troubleshooting Tips section.
Loading ...
Loading ...
Loading ...