Loading ...
Loading ...
Loading ...
8 49-80513-4
Care and Cleaning
Chimney Hood
Charcoal
filter
(on some
models)
If the model is not vented to the outside, the air
will be recirculated through a disposable charcoal
filter that helps remove smoke and odors.
The charcoal filter should be replaced when it
is noticeably dirty or discolored (usually after
6 to 12 months, depending on hood usage).
NOTE: DO NOT rinse, or put charcoal filter in
an automatic dishwasher.
The charcoal filter cannot be cleaned.
It must be replaced.
Order Charcoal Filter WB02X11348.
To inquire about purchasing replacement
charcoal filters or to find the location of a dealer
nearest you, please call our toll-free number:
Monogram Preferred Service: 800.444.1845
Monogram.com
To remove:
1. Remove the metal filter—see Metal grease
filter section.
2. Remove the charcoal filter in the same
manner as the metal grease filter by
pressing the
filter latch in to
release it. Pull
the filter down
and out.
To replace:
1. Insert the black charcoal filter into the
opening. Push the latch on both sides
toward the center and engage the flange.
2. Replace the metal filter—see Metal grease
filter section.
Stainless
steel hood
surfaces
Light bulbs
Regularly polish the stainless steel exterior
with Stainless Steel Magic™ and the
Monogram polishing cloth, to preserve and
protect the fine finish.
To avoid scratching the fine finish of the
stainless steel, wipe in the same direction
as the grain when polishing or cleaning any
stainless steel surface.
For regular cleaning, use clean water and
a soft cloth. If stains persist, wash with mild
dish soap using a soft cloth or nonabrasive
pad. For more difficult stains, make a solution
consisting of 25% vinegar (white or red) and
75% water. Dip a soft cloth into the solution
and rub onto the stainless steel to remove
the stain. If these methods do not remove the
stains, dirt or debris, call 800.444.1845.
NOTE: Reapply Stainless Steel Magic™ with
the Monogram polishing cloth after cleaning
or if your unit comes in contact with water, to
protect the fine finish.
Stainless Steel Magic™ and the Monogram
polishing cloth are available through
Monogram Parts and Accessories,
800.444.1845 or Monogram.com.
For Stainless Steel Magic™, order part
number WX10X15.
Do not use appliance wax or polish on any
stainless steel surface.
Do not use scouring pads, powdered
cleaners, bleach or cleaners containing
bleach because these products can scratch
and damage the finish.
Warranty does not cover damage due to
improper cleaning methods.
CAUTION
Allow bulbs to cool before
touching.
To change the light bulbs:
1. Press and turn the light bulb face 1/4 turn.
2. The bulb will drop straight out.
3. Replace with the same size bulb by placing
bulb prongs into the keyhole slots and
turning 1/4 turn to lock in place.
These 120 volt, 50 watt, MR16 halogen
bulbs with GU10 bases are available at most
specialty lighting stores, building centers and
large retailers. Ask for MR16 GU10 base bulb.
NOTE: Do not replace with bulbs greater
than 120 volts, 50 watts, or the lights will
automatically shut off and the rings around
the operating buttons will flash to indicate the
bulbs have exceeded the acceptable limits.
Loading ...
Loading ...
Loading ...