Loading ...
Loading ...
Loading ...
13
Troubleshooting
First try the solutions suggested here or visit our website at www.amana.com/help for assistance
and to possibly avoid a service call.
If you experience Possible Causes Solution
Dryer Operation
Dryer will not run Door not closed completely. Make sure the dryer door is closed completely.
START/PAUSE button not pressed
rmly or held long enough.
Touch and hold START/PAUSE 2–5 seconds.
Household fuse is blown or circuit
breaker has tripped.
There may be 2 household fuses or circuit breakers for the dryer.
Check that both fuses are intact and tight, or that both circuit breakers
have not tripped. Replace the fuses or reset the circuit breaker. If the
problem continues, call an electrician.
Incorrect power supply. Electric dryers require 240-volt power supply. Check with a qualied
electrician.
Wrong type of fuse. Use a time-delay fuse.
Dryer will not heat Household fuse is blown or circuit
breaker has tripped.
The drum may be turning, but you may not have heat. Electric dryers
use 2 household fuses or circuit breakers. Replace the fuses or reset
the circuit breaker. If the problem continues, call an electrician.
Incorrect power supply. Electric dryers require 240-volt power supply. Check with a qualied
electrician.
Supply line valve not open. For gas dryers, make sure that the valve on the gas supply line is open.
Unusual Noise
Thumping noise Dryer hasn’t been used in a while. This is due to temporary at spots on the drum rollers. The thumping
sound will diminish after a few minutes.
Rattling or vibrating
noise
A small object caught between the
edges of dryer drum.
Check the front and rear edges of the drum for small objects. Clean
out pockets before laundering.
Dryer isn’t properly leveled. The dryer may vibrate if not properly installed. See the Installation
Instructions. All four dryer feet should be in rm contact with the oor.
Clothing is balled up in dryer. When balled up, the load will bounce, causing the dryer to vibrate.
Separate the load items and restart the dryer.
Clicking noise Gas valve operating. On gas dryers, you may hear the gas valve clicking as it opens and
closes. This is normal.
Loud humming or
increased noise during
cycle
Load is packed tightly or exhaust
vent is blocked.
Reduce load size to recommended load size in “Cycle Guide.”
Run the dryer for 5–10 minutes. Hold your hand under the outside
exhaust hood to check air movement. If you do not feel air movement
or air movement is minimal, clean exhaust system of lint or replace
exhaust vent with heavy metal or exible metal vent. See the
Installation Instructions
Dryer Results
Clothes are not drying Lint screen is clogged with lint. Clean lint screen before each load.
satisfactorily or drying
times are too long
The exhaust vent or outside
exhaust hood is clogged with lint,
restricting air movement.
Run the dryer for 5–10 minutes. Hold your hand under the outside
exhaust hood to check air movement. If you do not feel air movement
or air movement is minimal, clean exhaust system of lint or replace
exhaust vent with heavy metal or exible metal vent. See the
Installation Instructions.
The exhaust vent is not the correct
length.
Check that the exhaust vent is not too long or has too many
turns. Long venting will increase drying times. See the Installation
Instructions.
The exhaust vent diameter is not
the correct size.
Use 4" (102 mm) diameter vent material.
The dryer is not level. Clothes not contacting the moisture sensors during Automatic cycles.
See “Level Dryer” in the Installation Instructions.
The Air Only temperature setting
has been selected.
Select the correct temperature for the types of garments being dried.
See “Cycle Guide.”
Loading ...
Loading ...
Loading ...