Loading ...
Loading ...
Loading ...
18
Oven smokes excessively during broiling.
Incorrect setting. Follow broil instructions in Setting Oven Controls.
Broiler drawer is open. Be sure broiler drawer is closed.
Meat too close to broil burner. Reposition the broiler drawer rack to
provide proper clearance between the meat & the burner.
Meat not properly prepared. Remove excess fat from meat. Cut remaining
fatty edges to prevent curling, but do not cut into lean.
Broiler pan and insert wrong side up and grease not draining. Always
place insert on the broiler pan with ribs up & slots down to allow grease
to drip into pan.
Grease built up on drawer surfaces. Regular cleaning is necessary when
broiling frequently. Old grease or food spatters cause excessive smoking.
Flames inside oven or smoking from
oven vent.
Excessive spillovers in oven. For example this will happen for pie
spillovers or large amounts of grease left on the oven bottom. Wipe up
excessive spillovers before starting oven. If ames or excessive smoke
are present see “Setting broil” in the Setting Oven Controls.
Oven control panel beeps & displays
any F code error.
Oven control has detected a fault or error condition. Press clear off to
clear the display & stop beeping. Try the bake or broil feature again. If
the F code error repeats, remove power from appliance, wait 5 minutes
and then repower appliance and set clock for the time of day. Try the
bake or broil feature again. If the fault recurs, record fault and call for
service.
Problem Solution
Oven light does not work.
Cannot move appliance easily. Appliance
must be accessible for service.
Cabinets not square or are built in too tightly. Contact builder or installer to
make appliance accessible.
Carpet interferes with appliance. Provide sufcient space so appliance can
be lifted over carpet.
Appliance is not level.
Be sure oor is level, strong & stable enough to adequately support
range.
If oor is sagging or sloping, contact a carpenter to correct the situation.
Poor installation. Place oven rack in center of oven. Place a level on the
oven rack. Adjust leveling legs at base of appliance until the rack is level.
Kitchen cabinet alignment may make range appear not level. Be sure
cabinets are square & have sufcient room for appliance clearance.
Be sure the light is secure in the socket. Also see “Replacing oven light” in
the Care & Cleaning section.
BEFORE YOU CALL • Solutions to common problems
Loading ...
Loading ...