Loading ...
Loading ...
Loading ...
13
Operating the Dishwasher
Start the dishwasher
1 Open the door and press the [On/Off] button. The Auto cycle LED flashes.
2 Select the desired cycle and options.
3 Press [Start] and close the door to begin the cycle.
NOTE: Your dishwasher is protected against unintentional operation. If the appliance door remains open for more than 4 seconds
after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] button again and close the appli-
ance door.
Cancel a cycle
1 Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.
2 Press and hold the [Start] button for approximately 3 seconds until the display reads “0:01”.
3 Close the door and wait about 1 minute while the dishwasher drains.
4 Open the door and press the [On/Off] button.
NOTE: Your dishwasher is protected against unintentional operation. If the appliance door remains open for more than 4 seconds
after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] button again and close the appli-
ance door.
Interrupt a cycle
1 Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.
2 Press the [On/Off] button to turn the unit off.
3 To resume the cycle, press the On/Off button and close the dishwasher door.
NOTE: Your dishwasher is protected against unintentional operation. If the appliance door remains open for more than 4 seconds
after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] button again and close the appli-
ance door.
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
To change the setting:
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 4) and press [Start] until the display indicates “H:00”.
3 Release both buttons.
4 Press the “A” button until the display shows “r:05”.
5 Press the “C” button to select the desired setting.
“r:00” = dispenser is OFF
“r:01” = lowest setting
“r:02” = low setting
“r:03” = medium setting
“r:04” = medium/high setting
“r:05” = high setting
“r:06” = highest setting
6 Press [Start] to save the setting and close the door.
InfoLight®
A LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the LED is not visible.
To change the setting:
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 4) and press [Start] until the display indicates “H:00”.
3 Release both buttons.
4 Press the “A” button until the display shows “1:01”.
5 Press the “C” button to switch between “1:01” = ON and “1:00” = OFF and press [Start] to save.
Loading ...
Loading ...
Loading ...