Loading ...
Loading ...
Loading ...
24 25
INSTALLING THE GAS ELEVATED COOKER
The cooker also comes supplied with a LPG gas conversion
kit, should you need to convert the gas from NG to LPG.
Alternatively, you can obtain these by contacting the
Customer Care Centre. Before installation check that
the cooker is suitable for the gas supply. For LPG it is
recommended to have the conversion completed prior to
installation on the bench.
The following table shows the supply and operating
pressures for various supplies.
INSTALLING THE GAS ELEVATED COOKER
Gas requirements
This appliance must be installed by an authorised person,
according to all codes and regulations of:
• AS/NZS 5601.1 (particular attention to clause 6.10.1 and
figure 6.3 on page 97, and clause 6.10.1.5 and 6.10.1.6
• Local gas fitting regulations, municipal building codes
and other statutory regulations.
GAS TYPE NATURAL GAS UNIVERSAL LPG PROPANE
Supply pressure at inlet to appliance regulator
(if fitted)
1.13 (kPa)
Minimum
2.75* (kPa) 2.75* (kPa)
Operate pressure at appliance test point 1.00 (kPa) 2.75 (kPa) 2.75 (kPa)
* If the regulator is placed upstream of the cooker inlet, as is normal for cookers operating on LPG, then the supply
pressure and operating pressure are the same.
The following table shows the injector sizes for each burner.
INJECTOR NATURAL GAS UNIVERSAL LPG PROPANE
Low heat burner 1.00 mm 0.55 mm 0.62 mm
Medium heat burner 1.35 mm 0.70 mm 0.82 mm
High heat burner 1.60 mm 0.90 mm 0.95 mm
Grill – main injector 1.50 mm 0.82 mm 0.82 mm
Oven – main injector 1.60 mm 0.82 mm 0.95 mm
Oven – bypass screw 0.73 mm 0.45 mm 0.45 mm
Checking pipe size
To work out a suitable pipe size for connection use the information in this table.
NATURAL GAS UNIVERSAL LPG PROPANE
Configuration STD Hob STD Hob STD Hob
Hourly gas consumption for cooker 57.2MJ 45.7MJ 56.5MJ
Also use information about the length of the run, number of elbows, tees and bends, the available service pressure and
the supply requirements. AS/NZS 5601.1 will help you with this matter.
Wiring connection for gas cooker (if applicable)
To allow for disconnection of the appliance after
installation, the plug must be accessible after installation.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Loading ...
Loading ...
Loading ...