Loading ...
Loading ...
Loading ...
9
EN
CHILD LOCK FUNCTION
To activate it, press the light button (10) for 3 seconds, until the child lock indicator turns on. To exit this mode,
press the light button again for 3 seconds, until the child lock indicator turns o.
Under the child lock function, the other buttons are locked.
TIMER / DELAYED START
• If the appliance is on: you can use this button to dene the operating duration. Briey press the button to
select the number of operating hours desired (1, 2, 4 or 8) and the appliance will automatically turn o at the
end of the selected period.
• If the appliance is o: briey press the button to set the appliance to turn on in a certain number of hours
(1, 2, 4 or 8).
MAINTENANCE
Always switch the appliance o with the button (13) and unplug it before conducting any maintenance
operation.
You can clean the appliance with a slightly damp cloth.
IMPORTANT: Never use abrasive products which could damage your appliance’s appearance.
This data is based on an average use of 8 hours per day at speed 1. The recommended frequency for cleaning and
replacing the lters may vary depending on the duration of use and the operating environment.
The lter needs to be cleaned or replaced when the corresponding indicator is turned on.
Note: when your appliance stops ltering, please check if you need to change the lter.
• When the pre-lter needs to be cleaned, its warning light on the control panel switches on.
• When the 2 in 1 HEPA and active carbon lter needs to be replaced, its warning light on the control panel switches
on.
• When the NanoCaptur lter needs to be replaced, its warning light on the control panel switches on.
The NanoCaptur lter contains translucent granules which change color according to the formaldehyde
absorption rate. Refer to the color chart on the inside of the panel or the lter itself to establish the lter saturation
rate. Once the saturation rate has reached its maximum, the lter must be replaced. You have to check the lter
saturation rate every six months.
• The pre-lter can be re-used: remove the dust using a vacuum cleaner or wash with water.
IMPORTANT: resetting the filters
Once the lter has been replaced, hold down the lter function for 3 seconds.
Forced reset:
If you have replaced a lter before its end of life, force the reset of the lter replacement cycle:
1. When the appliance is on, hold the reset button (11) for 3 seconds.
2. Press the reset button briey to select the lter you have changed.
3. After selecting the lter to reset, hold the reset button (11) for 3 seconds. The electronic meter is then reset.
4. If no button is activated for 10 seconds in forced reset mode, the reset mode is canceled.
Filters Action Cycles
Pre-lter Clean Every 2 or 4 weeks
2 in 1 HEPA and active carbon lter Replace Every 36 months
NanoCaptur lter Replace Every 12 months
FILTERS
Loading ...
Loading ...
Loading ...