Loading ...
Loading ...
Loading ...
LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example in a wet basement or near a sink.
• This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled (garages, porches, vehicles, etc.).
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 47 cm (18.5 inches) wide by
82.2 cm (32.4 inches) high by 40 cm (15.7
inches) deep.
• Allow 12.7 cm (5 inches) of space between the
back, sides and top of the appliance and all
adjacent walls.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
3
INSTALLATION INSTRUCTIONS OPERATING INSTRUCTIONS
TEMPERATURE SELECTION
The temperature of the appliance can be adjusted
by turning the thermostat dial in the upper left hand
corner of the interior compartment.
Higher numbers indicate the coldest setting.
Lower numbers indicate the warmest setting.
The “0” position will turn off the cooling function.
Internal temperature of the appliance can vary
based on ambient temperature, the quantity of items
stored and how frequently the door is opened.
LEVELING INSTRUCTIONS
There is an adjustable leg on the bottom of the
appliance that can be turned up or down to ensure
that the appliance is level.
1. Turn the leveling leg counter-clockwise as far as
it will go, until the top of the foot is touching the
bottom of the cabinet.
2. Slowly turn the leveling leg clockwise until the
appliance is level.
Loading ...
Loading ...
Loading ...