Loading ...
Loading ...
Loading ...
5
Microwave Oven Use
For list of preset programs, see the Quick Reference Guide provided with your model.
Manual Cooking/Stage Cooking
Touch COOK TIME, touch number keypads to enter time, touch
COOK POWER (if not 100%), touch number keypads to enter
power level (10-90), then touch the Start control.
If programming additional stages (up to three), touch OPTIONS/
CLOCK to enter programming for the next stage, then enter the
cook time and cook power of each, then touch the Start control.
Sensor Cooking
A sensor in the microwave oven detects moisture released from
food as it heats and adjusts the cooking time accordingly.
Make sure microwave oven has been plugged in for at least
1 minute. Use microwave-safe dish with loose-fitting lid or cover
microwave-safe dish with plastic wrap, and vent. For optimal
performance, wait at least 30 minutes after convection cooking
or grilling (on some models) before sensor cooking.
Add More Time
At the end of any cycle, “PRESS 0 TO ADD MORE TIME” scrolls
in the display. Enter the additional time, if desired, and start the
microwave oven. The cook power for all non-sensor cycles will
be the same as in the finished cycle, but may be changed. If Add
More Time is used after a sensor cycle, the cook power will be
100%, but may be changed.
Doneness
Adjust doneness for automatic cooking functions by touching
COOK TIME repeatedly to scroll through “NORMAL,” “MORE
DONE”, or “LESS DONE” within the first 20 seconds of starting
the cook cycle. Doneness cannot be adjusted for Defrost
functions.
Warm Hold
Hot cooked food can be kept warm in the microwave oven. The
Warm Hold function uses 10% cook power. Warm Hold can be
used by itself or can be programmed to follow a cooking cycle.
Opening the door during Warm Hold will cancel the function.
General Cleaning
IMPORTANT: Before cleaning, make sure all controls are OFF and
the microwave oven is cool. Always follow label instructions on
cleaning products.
To avoid damage to the microwave oven caused by arcing due
to soil buildup, keep cavity, microwave inlet cover, cooking rack
supports, and area where the door touches the frame clean.
Clean with mild soap, water, and a soft cloth or sponge or as
indicated below.
■ Nonstick cavity coating (on some models): To avoid damage to
the microwave oven cavity, do not use metal or sharp utensils
or scrapers or any type of abrasive cleanser or scrubbers.
■ Grease filter: mild soap and water or dishwasher.
■ Door and exterior: mild soap and water, or glass cleaner
applied to paper towel.
■ Control panel: sponge or soft cloth and water.
■ Stainless steel (on some models): mild soap and water, then
rinse with clean water and dry with soft cloth, or use stainless
steel cleaner.
■ Turntable: mild soap and water or dishwasher.
■ Rack(s): mild soap, water, and washcloth. Dishwasher cleaning
is not recommended.
Installing/Replacing Filters and Light Bulbs
NOTE: A Filter Status indicator (on some models) appears in the
display when it is time to replace the charcoal filter, and clean or
replace the grease filters. See the “Settings” section to reset filter
status.
■ Grease filters: Grease filters are on the underside of microwave
oven. Clean monthly or as prompted by Filter Status indicator.
Slide the filter away from the tab area, and drop out the filter.
To reinstall, place end of the filter into the opening opposite
the tab area, swing up the other end, and slide it toward the
tab area.
■ Charcoal filter: The charcoal filter is behind the vent grille at
the top front of the microwave oven. The charcoal filter cannot
be cleaned and should be replaced about every 6 months.
Remove 2 screws on the vent grille, slide the vent grille to the
left, tilt it forward, lift it out, and remove the filter. To reinstall,
place the filter into its 2-hook area with the wire mesh side to
the front. Replace the vent grille by inserting the 3 bottom latch
hooks of the vent grille into the front holes, tilt the vent grille
backwards, slide it to the right, and secure with screws.
■ Cooktop light: The cooktop light is located on the underside
of the microwave oven and is replaceable. Remove bulb cover
screw and open the bulb cover. Replace bulb, close bulb
cover, and secure with screw.
■ Cavity light: The cavity light bulb is located behind the vent
grille at the top front of the microwave oven, under the bulb
cover, and is replaceable. Remove 2 screws on the vent grille,
slide the vent grille to the left, tilt it forward, and lift it out. Open
the bulb cover and replace bulb. To reinstall, close bulb cover.
Replace the vent grille by inserting the 3 bottom latch hooks of
the vent grille into the front holes, tilt the vent grille backwards,
slide it to the right, and secure with screws.
MICROWAVE OVEN CARE
Loading ...
Loading ...
Loading ...