Loading ...
Loading ...
Loading ...
V40DG2EBK AL-V40DG2E4
User Manual
It is hazardous for anyone other than an Authorised Service Person to carry out
servicing or repairs to this appliance.
– WARNING: Keep ventilation openings in the appliance enclosure or in the built-in
structure clear of obstruction.
– WARNING: Do not use mechanical devices or other means to accelerate the defrosting
process, other than those recommended by the manufacturer.
– WARNING: Do not dam
age the refrigerant circuit.
– WARNI
NG: Do not use electrical appliances inside the compartments.
– WARNING: In Queensland Australia, the authorized person must hold a Gas Work
Authorisat
ion for hydrocarbon refrigerants, before carrying out
servicing or repairs which
involve the removal of covers.
The environment and personal safety must be considered when disposing of this appliance.
Please ensure the appliance is taken to a recycle center for safe recycling. DO NOT
dispose of the appliance in land fill as the insulation and refrigerant gas contained in these
appliances are flammable.
Allow 24 hours before switching on the wine cellar. During this time we recommend
that you leave the door open to clear any residual odors.
BEFORE LOADING & PLUGGING IN THE WINE CELLAR
Important: All models without front venting (air opening) are strictly for free standing
only. (See technical chart)
Recommendations:
The location you have selected for your wine cellar should:
- be unencumbered and well ventilated;
-
be well away from any heat source and direct sunlight;
- not be too damp (laundry, pantry, bathroom etc.);
-
have a flat floor;
- have a standard and reliable electricity supply (standard socket to country standards,
linked to the ground), it is NOT recommended to use a multi-socket or extension lead;
- have a surge protector fitted to the electrical outlet;
- away from the microwave oven. Certain microwave ovens do not have wave interference
shield. When placed within 1 meter vicinity of the wine cabinet, they may affect the
operation of the wine cabinet.
The wine cellar should be placed where the ambient temperature is between 5ºC to 35ºC.
If the ambient temperature is above or below this range, the performance of the unit may
be affected. Placing your unit in extreme cold or hot conditions may cause interior
temperatures to fluctuate. The ideal range of temperature may not be reached. (See
Climate Class at the end of this manual)
Grounding instructions
The wine cellar must be grounded in case of an electrical short circuit. Grounding reduces
the risk of electrical shock. The wine cellar is equipped with a power cord having a
grounding wire and plug. The wine cellar plug must be plugged into a properly affixed and
grounded electrical outlet.
Note: In locations where there is frequent lightning, it is advisable to use surge
protectors.
Improper use of the grounding plug can result in the risk of electric shock. Consult a
qualified electrician or service person if the grounding instructions are not completely
understood.
If the supply cord is damaged, it must be replace by a qualified person in order to avoid
electrical hazard.
INSTALLING YOUR WINE CELLAR
Unpack and remove all of the protection and adhesive strips from
the packaging around
and inside the wine cellar.
The wine cellar must be positioned such that the plug is accessible. Release the power
cord. Move your wine cellar to its final location. The wine cellar should be installed in a
suitable place where the compressor will not be subject to physical contact.
Leveling your wine cellar: Wine cellar must be leveled BEFORE loading your wines.
Your Vintec wine cellar is equipped with 4 adjustable feet to facilitate easy leveling.
VINTEC recommends that you tighten the back feet to the maximum and adjust the front
feet to level the wine cellar.
Loading ...
Loading ...
Loading ...