Loading ...
Loading ...
Loading ...
Reset
Should your set receive external interference e.g. static electricity from carpets, thun-
derstorms, etc. RESET allows you to clear all previous settings and start up again.
• Use a ballpoint pen to press the RESET hole found on the bottom of the set.
CONNECTING AN EXTERNAL DEVICE
You can listen to the sound of the connected external device through your
AJ300D’s speakers.
1
Press
TUNER/AUX
twice to select AUX mode.
2
Use the supplied AUX-IN cable to connect AJ300D’s AUX IN jack to an
AUDIO OUT or headphone jack on an external equipment (such as CD player,
or VCR).
MAINTENANCE & SAFETY
•
Install the unit near the AC outlet and where the AC power plug can be easily
reached.
•
The apparatus shall not be exposed to dripping or splashing.
•
Do not expose the set to humidity, rain, sand or excessive heat caused by
heating equipment or direct sunlight.
•
To clean your set, use a soft damp cloth or chamois leather. Do not use clean-
ing products, which contain benzene, thinner, etc. as these may harm the
housing.
•
Where the MAINS plug or an appliance coupler is used as the disconnect
device, the disconnet device shall remain readily operable.
•
Batteries (battery pack or batteries installed) shall not be exposed to exces-
sive heat such as sunshine, fire or the like.
SPECIFICATIONS
Power Consumption........................................................................................24 W
Output power .....................................................................................2 x 6 W RMS
Dimensions (w x h x d) .........................................................161 x 191 x 164 (mm)
Weight..........................................................................................................1.34 kg
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock!
No sound
– Volume not adjusted
• Adjust the volume
– The set is muted.
•Press”MUTE” on the remote control to active playback sound.
Display error / no reaction to any controls
– Electrical malfunction
•
Press the RESET hole on the bottom of the set with a ball-pen.
Intermittent crackling sound during FM reception
– Weak signal
•
Extend and position the pigtail aerial
The alarm does not function
–
Alarm time/ mode not set
• See SETTING THE ALARM (Dock mode is only available to iPod.)
– Volume too low for radio
• Increase the volume
Dock operation
–
The menu navigation or photo playback of the docked player cannot be car-
ried out through the buttons on AJ300D or its remote control.
• The buttons on AJ300D and its remote control can control playback of audio con-
tents only. To navigate the menu, use the controls on the docked player.
–
Some buttons on AJ300D and its remote control have no function.
• The buttons ( 2; , ¡1, 2™ and VOLUME ) function only. For Philips GoGear, fast
forwarding/rewinding is not available.
AJ300D_37-Eng 6/10/08 15:29 Page 8
Loading ...