GE - General Electric GE 230 Volt Electronic Room Air Conditioner AEH24DJH1

User Manual - Page 5

For AEH24DJH1.

PDF File Manual, 36 pages, Download pdf file

Loading ...
Loading ...
Loading ...
GEAppliances.com
COOL Mode
Use the COOL mode with HIGH, MED or LOW fan
for cooling. Use the TEMPERATURE INCREASE /
DECREASE pads to set the desired temperature
between 64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the
room temperature. The compressor will cycle on
and off to keep the room at the set level of comfort.
Set the thermostat at a lower number and the indoor
air will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to COOL, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—Select the COOL mode and
HIGH or MED fan with a middle set temperature.
For Maximum Cooling—Select the COOL mode
and HIGH fan with a lower set temperature.
For Quieter & Nighttime Cooling—Select the
COOL mode and LOW fan with a middle set
temperature.
NOTE: If you switch from a COOL setting to OFF or to a fan
setting, wait at least 3 minutes before switching back to a
COOL setting.
FAN Mode
Use the FAN at HIGH, MED or LOW to provide air
circulation and filtering without cooling. Since fan
only settings do not provide cooling, a temperature
setting will not be displayed.
Consumer Support
Troubleshooting Tips
Operating InstructionsSafety Instructions Installation Instructions
Vent Control
The vent control is located above the control
panels.
When set at CLOSE, only the air inside the room
will be circulated and conditioned. When set at
OPEN, some outside air is let into the room.
To open the vent, push the lever to the right.
To close it, push it to the left.
5
Air Direction—Up and Down
Fingertip pressure on the horizontal louvers
adjusts the air direction up or down.
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored. The TIMER feature
will reset to the original setting. You may need to set
a new time if desired.
Power Outage Recovery Feature
Control Panel Door
Press to open and close the door.
Loading ...
Loading ...
Loading ...