Loading ...
Loading ...
important Notes to the installer
1. Read att instructions contained in these
installation instructions before installing the wall
oven.
2. Remove all packing material from the oven
compartments before connecting the electrical
supply to the watt oven.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the
consumer.
5. Oven door may be removed to facilitate
installation.
6. THESE OVENS ARE NOT APPROVED FOP,
STACKABLE OR SIDE-BY-SIDE INSTALLATION.
2. Adjusting Oven Height
Remove and lay aside the lower vent decorative
trim that is taped to the outer side panel of the
oven. The decorative trim will be fastened to the
lower front of the oven after it has been installed
in the cabinet.
There is a 13ΒΌ" (4.4 cm) height adjustment on
models with extension panel (see figure 3).
With this adjustment and a 1/4" (0.6 cm) trim
overhang, a single oven can be installed in
existing openings 27s/8 '' (70.2 cm) to 29s/8 ''
(75.2 cm) or a double oven in existing openings
48" (121.9 cm) to 50" or 49 7/8" (127 cm or
126.7 cm) high.
important Note to the Consumer
Keep these instructions with your Owner's Guide for
future reference.
iMPORTANT SAFETY
iNSTRUCTiONS
* Be sure your wall oven is installed and
grounded properly by a qualified installer or
service technician.
* This wall oven must be electrically grounded in
accordance with local codes or, in their absence,
with the Natlonal Electrlcal Code ANSI/NFPA
No.70- latest edition in United States, or with
CSA Standard C22.1, Canadian Electrlcal Code,
Part 1, in Canada.
Stepping, leaning or sitting an the
door of this wall oven can result in serious injuries
and can also cause damage to the wall oven.
* Never use your wall oven far warming or
heating the room. Prolonged use of the walt oven
without adequate ventilation can be dangerous.
The electrlcal power to the oven
must be shut off while llne connections are being
made. Failure to do so could result in serious
injury or death.
To
1.
2.
.
.
.
stmentHoles
_"_'_ _iiii_ Extension
Panel
Mounting Screws
Figure 3
adjust oven height:
Lay oven on its back (see figure 4).
Remove the 6 screws that fasten the side
extension panel to the bottom sides of the oven.
Move each panel down to the position that increases
the oven height to fit your opening. Each position
changes oven height approximately 1/2" (1.3cm).
Line up the appropriate holes in the side extension
panels and sides of the oven. Put back the 6
screws.
Return to upright position. Proceed with oven
installation.
OVEN DOOR
|. Carpentry
Refer to figure 1 or 2 for the dimensions applicable
to your appliance, and the space necessary to
receive the oven. The oven support surface may
be solid plywood or similar material, however the
surface must be level from side to side and front to
rear.
3
OVEN BOTTOM'
Figure 4
EXTENSION PANEL
Loading ...
Loading ...
Loading ...