Loading ...
Loading ...
Loading ...
22
CARE & CLEANING
• Chrome control panel (some models)
• Decorative trim (some models)
Surface type Recommendation
• Porcelain enamel broiler pan and
broiler pan insert (if equipped)
• Door liner & body parts
Use hot, soapy water and a cloth. Dry with a clean cloth.
For general cleaning, use hot, soapy water and a cloth. For more difcult
soils and built-up grease, apply a liquid detergent directly onto the soil.
Leave on soil for 30 to 60 minutes. Rinse with a damp cloth and dry. Do
not use abrasive cleaners on any of these materials; they can scratch.
To remove control knobs, turn to the OFF position; grasp rmly and pull
straight off the shaft. To replace knobs after cleaning, line up the at
sides of both the knob and the shaft; then push the knob into place.
Before cleaning the control panel, turn all controls to OFF and remove
the control knobs. To remove, pull each knob straight off the shaft. Clean
using hot, soapy water and a dishcloth. Rinse with a clean water using a
dishcloth. Be sure to squeeze excess water from the cloth before wiping
the panel; especially when wiping around the controls. Excess water in
or around the controls may cause damage to the appliance.To replace
knobs after cleaning, line up the at sides of both the knob and the
shaft; then push the knob into place.
If your range nish is Easy Care™ Stainless Steel (some models),
clean the stainless with warm soapy water using a clean sponge or
cloth. Rinse with clean water and dry with a soft clean cloth. DO NOT
use ANY store bought cleaners like Stainless Steel cleaners or any other
types of cleaners containing any abrasive, chlorides, chlorines or am-
monia. It is recommended to use mild dish soap and water or a 50/50
solution of water and vinegar.
• Painted and plastic control knobs
• Painted body parts
• Painted decorative trim
• Aluminum (trim pieces) & vinyl
Gentle scouring with a soapy scouring pad will remove most spots. Rinse
with a 1:1 solution of clear water and ammonia. If necessary, cover
difcult spots with an ammonia-soaked paper towel for 30 to 40 minutes.
Rinse with clean water and a damp cloth, and then scrub with a soap-
lled scouring pad. Rinse and wipe dry with a clean cloth. Remove all
cleaners or the porcelain may become damaged during future heating.
Do not use spray oven cleaners on the cooktop.
• Easy Care™ Stainless
Steel (some models)
• Oven racks
• Oven door
Oven racks must be removed from oven before starting
self-clean cycle. Clean by using a mild, abrasive cleaner following
manufacturer’s instructions. Rinse with clean water and dry.
Use soap & water to thoroughly clean the top, sides and front of the
oven door. Rinse well. You may use a glass cleaner on the outside glass
of the oven door. Do not immerse the door in water. Do not spray
or allow water or the glass cleaner to enter the door vents. Do
not use oven cleaners, cleaning powders or any harsh abrasive cleaning
materials on the outside of the oven door.
Do not clean the oven door gasket. On self-cleaning models the oven
door gasket is made of a woven material which is essential for a good
seal. Care should be taken not to rub, damage or remove this gasket.
See Cleaning the cooktop and surface burners instructions provided in
the following Care & Cleaning section.
Cleaning recommendation table
• Cooktop surface and contoured
well areas, surface burner heads
and caps
Loading ...
Loading ...
Loading ...