Loading ...
Loading ...
Loading ...
Care and storage
81
To rustproof the internal engine components:
(1) Remove the seat and fire extinguisher
holder. (See page 42 for seat removal
and installation procedures and page 47
for information on the fire extinguisher
holder.)
(2) Remove the plastic tie that is fastening
the fuel hose to the holder on the star-
board side of the air filter case.
(3) Release the hooks on the port side of the
air filter case, and remove the air filter
case cover.
(4) Spray a rust inhibitor such as Yamalube
Stor-Rite Engine Fogging Oil into the in-
take opening for 3 seconds. WARNING!
Do not spray flammable rust inhibitor
products on engine surfaces while the
engine is hot. The sprayed substance
or propellants could catch fire.
[EWJ00262]
(5) Place the air filter case cover in its origi-
nal position, and then fit the hooks onto
the cover.
TIP:
Make sure that the air filter case cover is se-
curely installed.
(6) Fasten the fuel hose to the holder using
the plastic tie.
(7) Make sure that the area around the wa-
tercraft is clear, and then start the engine
in a well-ventilated area and let it run at
idle for 15 seconds. (See page 30 for in-
formation on starting the engine.)
(8) Stop the engine.
(9) Securely install the fire extinguisher hold-
er and seat in their original positions.
1 Hook
2 Air filter case cover
3 Fuel hose
4 Holder
5 Plastic tie
1
2
3
4
5
1 Intake opening
1
UF4L11E0.book Page 81 Monday, June 24, 2019 2:27 PM
Loading ...
Loading ...
Loading ...