Loading ...
Loading ...
Loading ...
EN
3
washing by the producer on the relevant label. All other uses are to be considered
improper. The manufacturer declines all liability for uses other than those
stated above.
The nameplate with the technical data, serial number and mark is in a visible posi-
tion in the part in view after the door has been opened. The nameplate must never
be removed.
The electrical and plumbing works required to install the appliance must only
be carried out by skilled staff.
The appliance must be connected to earth in compliance with electrical system
safety regulations. The manufacturer declines all liability for direct or indirect
injury or damage deriving from a non-existent or defective earth connection.
In the event that the appliance is not connected by means of a plug, an omnipolar
circuit-breaker device with contact gap of at least 3 mm must be provided.
The plug to be connected to the power supply lead and the relative socket must be
of the same type and comply with the relevant regulations. Check that the mains
voltage and frequency are the same as the values marked on the nameplate. The
use of adapters or junctions is not recommended. Never disconnect the plug by
pulling on the power supply lead.
The appliance is only disconnected from the electricity supply if the plug has
been removed from the socket or the electrical system master switch has
been turned off. The power plug must be accessible after the appliance has
been installed.
WARNING: The appliance must not be supplied through an external switching de-
vice, such as a timer, or connected to a circuit that is regularly switched on and off
by a utility.
The appliance must be installed using new sets of hoses (supplied with the appli-
ance). Old hose sets should not be reused.
Take care that the appliance is not standing on the power supply cable.
The washer-dryer must never be used on vehicles, on board ships or planes, or in
environments with hazards, such as explosive or corrosive environments (powders,
vapours and gases) or explosive and/or corrosive liquids,
Do not install the washer-dryer in places with a risk of frost. Frozen pipes may burst
under the pressure.
Make sure that the drain hose connected to the sink is securely fastened and
cannot move.
If it is not fixed in place, the repulsive force of the water might thrust it away from
the sink, causing the risk of flooding.
When connecting the hose to a sink also check that the water drains from it
quickly, as otherwise the sink may overflow.
Do not overload the appliance.
Never use detergents which contain solvents or chemicals for washing in the
washer-dryer. They might damage the appliance and form poisonous vapours.
These fumes might also catch fire and explode.
Garments soaked in petroleum products must not be washed in the washing ma-
chine. Before washing, check that garments do not contain inflammable devices
(e.g. cigarette-lighters, matches, etc.)
If volatile cleaning fluids are used, ensure that these substances have been re-
moved from the garments before they are placed in the appliance.
Before loading garments for washing, check that the pockets are empty, buttons
secure and zips fastened.
Do not wash frayed or torn garments.
Loading ...
Loading ...
Loading ...