Loading ...
Loading ...
Loading ...
17
Troubleshooting
If you experience a problem with your appliance or are concerned that the
appliance is not functioning correctly, you can carry out some easy checks
before calling for service, please see below. You can carry out some easy
checks according to this section before calling for service.
Warning! Don't try to repair the appliance yourself. If the problem persists
after you have made the checks mentioned below, contact a qualified
electrician, authorized service engineer or the shop where you purchased the
product.
Caution!
-Don't use sharp objects as they are
likely to scratch the surface.
-Don't use Thinner, Car detergent,
Clorox, ethereal oil, abrasive cleansers
or organic solvent such as Benzene for
cleaning. They may damage the
surface of the appliance and may
cause fire.
Interior cleaning
You should clean the appliance interior
regularly. It will be easier to clean when
food stocks are low.
-Wipe the inside of the fridge freezer
with a weak solution of bicarbonate of
soda, and then rinse with warm water
using a wrung-out sponge or cloth.
-Wipe completely dry before replacing
the shelves and baskets. Thoroughly
dry all surfaces and removable parts.
Although this appliance automatically
defrosts, a layer of frost may occur on
the refrigerator's interior walls if the
door is opened frequently or kept
opentoo long. If the frost is too thick
wait until food stocks are low and
proceed as follows:
Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet and tear when
you open the door. Wash seal with a
mild detergent and warm water. Rinse
and dry it thoroughly after cleaning.
Caution! Only after the door seals are
completely dry should the appliance be
powered on.
Door seal cleaning
Caution! Don't use sharp objects to
remove frost from the refrigerator. Only
after the interior is completely dry
should the appliance be switched back
on and plugged back into the mains
socket.
1 . R e m o v e e x i s t i n g f o o d a n d
accessories baskets, unplug the
appliance from the mains power and
leave the doors open. Ventilate the
room thoroughly to accelerate the
thawing process.
2.When defrosting is completed, clean
your freezer as described above.
Warning: The LED light should not
be replaced by the user. If the LED
light is faulty, contact the
customer helpline for assistance.
To replace the LED light, the
following steps can be used:
1.Unplug your appliance.
2.Remove light cover by pushing up
and out.
3.Hold the LED cover with one hand
and pull it with the other hand while
pressing the connector latch.
4.Replace LED light and snap it
correctly in to place.
Replacing the LED light
Loading ...
Loading ...
Loading ...