Loading ...
Loading ...
Loading ...
1Place cooler on a dry surface where it is protected from water
2The cooler should not be used where it may be exposed to rain
3Never locate the cooler where the ambient temperature is
below0°C 32°F
..
..
.
().
1. Plug the DC/DC power cord into the cord socket on the side of
the unit (see upper figure on page 5).
2. If using a DC power source such as the cigarette lighter socket
of a vehicle, plug the other end of the cord into the power source.
3If using an AC power source, connect the AC/DC adapter to the
end of the DC/DC cord, then plug the adapter into a wall socket
or other AC power source.
4Press the power switch to turn on the cooler. (You will hear the
sound of the compressor starting.)
5. Press the Up or Down button on the control panel to adjust the
temperature. Pressing either button once will adjust the tempe-
rature by 1Celsius degree. The maximum cool setting is
-19°C (-2.2°F).
6. Five seconds after the desired temperature is set, you will hear
5 beeps to confirm the setting and the LED display will begin to
show the actual temperature inside the unit.
.
.
NOTE: The compressor will shut off if the internal temperature of
the unit is 1 Celsius degree or more below the set temperature.
When the internal temperature rises to 2 degrees above the set
temperature, the compressor will turn on again after an interval
of about 2 minutes.
Typicallyiftheambienttemperatureis30C86Fandthetemp-
eratureontheunitissetto18C04Ftheinterioroftheunit
willreachthefreezingpointofwater0Cinabout30minutes
andwillreachthesettemperatureinabout1½hours
, ° ( ° )
- ° (-.°),
( ° ) ,
.
• Place the cooler in a cool,dry place away from direct sunlight
• Before storing in the coolercool the items to be stored
• Do not set the temperature colder than you require
• Do not open the cooler more often than necessary
• Do not leave the lid open longer than necessary
.
,.
.
.
.
•
•
•
•
•
3