Loading ...
Loading ...
Loading ...
Winding/Installing the Bobbin 29
1
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
—
q
Remove the spool for the bobbin thread from
the spool pin, and then close the top cover.
Memo
z When the sewing machine is started or the
handwheel is turned after winding the
bobbin, the machine will make a clicking
sound; this is not a malfunction.
Installing the bobbin
Install the bobbin wound with thread.
CAUTION
a
Press (“Needle Position” button) once or
twice to raise the needle, and then raise the
presser foot lever.
b
Turn off the sewing machine.
c
Slide the bobbin cover latch to the right.
a Bobbin cover
b Latch
X The bobbin cover opens.
d
Remove the bobbin cover.
e
Hold the bobbin with your right hand and hold
the end of the thread with your left.
• Be careful not to drop the bobbin.
f
Insert the bobbin with your right hand so that
the end of the thread is on the left, and then,
after pulling the thread firmly around the tab
with your left hand as shown, lightly pull the
thread to guide it through the slit.
a Tab
● Use a bobbin that has been correctly
wound with thread, otherwise the needle
may break or the thread tension will be
incorrect.
●
The bobbin was designed specifically for
this sewing machine. If bobbins from other
models are used, the machine will not
operate correctly. Use only the included
bobbin or bobbins of the same type (part
code: SA156, SFB (XA5539-151)).
Actual size
11.5 mm
This model Other model
(7/16 inch)
1
Loading ...
Loading ...
Loading ...