Loading ...
Loading ...
Loading ...
7
H
F
My Cycle Settings
As the cycle selector knob is turned, the Time (Timed Dry), Level (Dryness Level), and Temp (Temperature) settings
change to automatic pre-set default settings. If you desire a different setting, press the appropriate button(s). Then
press and hold the My
Cycle Settings button for 3 seconds. The button light will turn on and the dryer will save these
settings for that knob selection. In the future, when you turn the selector knob to that cycle, your settings will be
automatically recalled.
To temporarily (for this load) return to the pre-set default settings, depress the My
Cycle Settings button for 1/2
second. The button light will turn off and the options will change back to these defaults. To make these default settings
permanent, hold the My
Cycle Settings button again for 3 seconds to make them your preferred settings (the button
light will turn back on). NOTE: Volume level cannot be set for My
Cycle Settings.
Volume
Use the Volume button to change the volume of the end of cycle and control signals. Press the button until you reach the
desired volume (low-med-high) or off. The clothes should be removed when the beeper goes off so wrinkles do not set in.
NOTE:
• Remove garments promptly at the sound of signal. Place clothes on hangers so wrinkles will not set in.
• Use the Volume especially when drying fabrics like polyester, knits and permanent press. These fabrics should be removed
so wrinkles will not set in.
Drum Light
The drum light will go on if the Drum Light button is pushed or the door is opened. It will stay on until the door is shut or the
Drum Light or Power button is pushed.
Lock Controls
You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started a
cycle. Children cannot accidentally start the dryer by touching buttons with this option selected.
To lock the dryer controls, press and hold the Lock Controls button for 3 seconds. The control lock icon will light up when locked.
To unlock the dryer controls, press and hold the Lock Controls button for 3 seconds.
NOTE: The Power button can still be used when the machine is locked.
eDry
Available for Bulky Items, Towels/Sheets, Cottons, Mixed Loads, Jeans, Casuals/Easy Care, Active Wear, and Delicates.
When the eDry button is pressed, cycle settings change to reduce the total energy consumption of the selected sensor cycle.
NOTE: Cycle times will change when eDry is selected. The eDry option will default to on for Cottons. For optimal energy
savings, turn eDry on. For optimal drying times, turn eDry off. NOTE: Energy savings will vary across loads and cycles.
The Efficiency Monitor lights display the relative energy use of your selected cycle and options. They are provided as an
energy guide and range from Good (1 light) to Better (5 lights). Cycle (time), dryness level, temperature, and additional tumble
options can increase or decrease your energy efficiency. Some special cycles will not provide a display.
GEAppliances.com
G
Options
Delay Dry
As the Delay Dry button is repeatedly pressed, the delay time sets to from 1 to 9 hours, and back to clear (0). After selecting
the delay time, press Start and the delay time will count down the time remaining until the cycle starts.
If the Delay Dry button is pressed for 3 seconds, it clears (regardless of the delay time) or terminates a delaying cycle.
Extended Tumble
Use this option to minimize the wrinkles in clothes. It provides 1 hour of no-heat tumbling after the clothes are dry. If you are
using the cycle Volume and you select the Extended Tumble option, a signal will sound at the end of the drying time and
every 5 minutes during the Extended Tumble cycle. This will remind you that it is time to remove the clothes.
Damp Alert
This option causes the dryer to beep when clothes have dried to a damp level. Remove items that you wish to hang dry. The
Damp Alert will only beep when this option is selected (but the dry cycle will keep running). Removing clothes and hanging them
when they are damp, can reduce the need to iron some items. The light beside the button will be lit when Damp Alert is on.
Rack Dry
Rack Dry is only allowed for timed cycles (Timed Dry & Air Fluff). The light turns off if cycle knob is turned to a non-timed cycle.
Temperature
High For regular to heavy cottons.
NOTE: Steam Dewrinkle and Steam Refresh require the High temperature setting.
Medium For synthetics, blends, delicates and items labeled permanent press.
Low For delicates, synthetics and items labeled tumble dry low.
Extra Low
For delicates, synthetics and items labeled tumble dry low.
No Heat For fluffing items without heat. For use only with the Timed Dry cycles.
E
Loading ...
Loading ...
Loading ...