Loading ...
Loading ...
Loading ...
1
Remove the battery cover at the
back of the remote control.
2
Insert batteries in the compartment,
making sure the ± and —
polarities are correctly aligned.
• Lines will be indicated on the dis-
play when batteries are properly
installed.
3
Reinstall the battery cover.
4
Press the RESET button using a
thin stick.
USING THE REMOTE CONTROL
9
NOTES:
• The battery life is approximately one year in normal use.
• When you replace the batteries, always change both batteries, and make sure they are the
same type.
• If the remote control does not operate properly after replacing the batteries, press the
RESET button using a thin stick.
• If you will not be using the unit for a long time, remove the batteries from the remote
control.
Point the remote control towards
the unit’s signal receiver window
and press the desired button. The
unit generates a beep when it re-
ceives the signal.
• Make sure there is no curtain or other
object between the remote control and
the unit.
• The remote control can send signals
from up to 7 metres away.
LOADING BATTERIES Use two size-AAA (R03) batteries.
HOW TO USE THE REMOTE CONTROL
Remote control
cover
{
{
|
|
CAUTION
• Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely
affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to
block the light.
• Using a fluorescent lamp with a quick starter in the same room may interfere with transmission of
the signal.
• The unit can be affected by signals transmitted from the remote control of a television, VCR or
other equipment used in the same room.
• Do not leave the remote control in direct sunlight or near a heater. Also, protect the unit and
remote control from moisture and shock which can discolour or damage them.
Loading ...
Loading ...
Loading ...