Loading ...
Loading ...
Loading ...
70
MAINTENANCE
Oil and Filter Change
Oil Pump Priming
This priming procedure must be per-
formed whenever the oil hose connection
between the oil tank and pump inlet has
been disconnected.
1. Clamp or pinch off the vent line
approximately 2" (5 cm) from the oil
tank, between the end of the oil tank
vent fitting and the vent line's pres-
sure relief slit.
2. Start the engine. Allow it to idle for
10-20 seconds.
3. Remove the vent line clamp. If the line is bled properly, you should
hear a rush of air, indicating that the line is properly primed and
ready for operation.
Tip: If you do not hear air, the line has not bled. Repeat the priming procedure.
Transmission Oil
Always check and change the transmission oil at the intervals outlined
in the Periodic Maintenance Chart beginning on page 60. Maintain the
oil level at the bottom of the fill plug hole threads. See page 113 for the
part numbers of POLARIS products.
The fill plug is located on the left side of the ATV, under the rear fender,
behind the wheel. The drain plug is located on the right side of the
gearcase, on the right side of the ATV, behind the wheel well.
Clamp
Pressure
Relief Slit
Tank
2"
(5 cm)
Drain Plug
Fill Plug
Loading ...
Loading ...
Loading ...