Loading ...
Loading ...
Loading ...
19PREPARING FOR USE
PREPARING FOR USE
WARNING
CAUTION
Solubility of the tablet detergents produced by different
companies can vary depending on the temperature
and time� Therefore, it is not recommended to use such
detergents in short programs� It is more suitable to use
powder detergents in such programs�
Should any problem, which you have not encountered
before, arise with the use of this type of detergents,
contact the detergent manufacturers directly�
When you give up using combined detergents
• Fill the salt and rinse aid compartments�
• Adjust the water hardness setting to the highest
position (6) and run an empty-wash�
• Adjust the water hardness level�
• Make the suitable rinse aid setting�
Filling with rinse aid and making the setting
1
2
3 4
5
6
Rinse aid is used to prevent the stay of white water
drops, lime stains, white film strip-shaped stains that
may form on the dishes, as well as to increase the drying
performance� Contrary to the popular beliefs, it is used
not only for obtaining shinier dishes but also for obtaining
sufficiently dried dishes� For this reason, care should
be taken that there is adequate amount of rinse aid in
the rinse aid compartment and only polishing material
produced for use at dishwashers should be used� If the
rinse aid lamp on the control panel becomes on fill the
rinse aid compartment with rinse�
1
2
3 4
5
6
To put rinse aid, remove the rinse aid compartment cap
by turning it� Fill the rinse aid compartment with rinse aid
until the rinse aid level indicator becomes dark
1
;
refit the cap and close it by turning it in a way that the
nails will correspond to one another
2
� By checking the
rinse aid level indicator on the detergent dispenser, you
can understand whether or not your machine needs rinse
aid� A dark indicator
b
means that there is rinse aid in the
compartment, while a light indicator
a
shows that you
need to fill the compartment with rinse aid�
1
2
3 4
5
6
The rinse aid level adjuster can be set to a position
between 1 and 6� Factory setting for rinse aid is the
position 3� You need to increase the degree of the
adjuster if water stains form on your dishes after a wash,
whereas you need to decrease the degree if a blue stains
left when wiped by hand�
3
WARNING
CAUTION
Use only those rinse aid materials which are allowed for
use in the machine� As rinse aid residues left as a result of
overflowing will create extremely high amounts of foam
and thus reduce the washing performance, remove the
excess amount of rinse aid by wiping it with a paper towel
or cloth�
2
3
a
b
Loading ...
Loading ...
Loading ...