Loading ...
Loading ...
Loading ...
5. Placethreadedjarnutorthreadedjarskirtover
blade and jar (Note: If there are slots on top of
collar, line them up with notches on jar.) Place the
threadedjarnutorthreadedjarskirtonjarandturn
itclockwisetotighten. (Figure 4)
6. Place jar assembly onto base. (Figure 5)
7.
Line up tabs of jar with tabs on blender base.
Makesurethetabofthejaronthe
left
side is in the
backofthetaboftheblenderbaseandthetabof
the jar on the right side is in front of the tab of the
blenderbase.Makesurejarisseatedintoposition.
(Figure 6)
8. Place ingredients into jar.
9. Place lid with feeder cap on jar.
10. Plugthepowercordintoa120Volt
AC electrical outlet.
11. SlideswitchtoHIGHorLOW. (If your model does
not have a slide switch, push HIGH or LOW button.)
12. Push desired speed and blend ingredients
to desired consistency.
13. Press OFF to stop the blender.
14.TousePULSE,selectHIGHorLOW.PushPULSE
and hold down for desired length of time. Release
PULSE and allow blade to stop. Repeat cycle as
desired.
Blending Tips
•Putliquidsinthejarfirst,unlessarecipesaysotherwise.
•Crushingice:Crush6icecubesorapproximately2cups
of ice at a time.
•Donotremovethelidwhileinuse.Removefillercapto
add smaller ingredients. (Figure 7)
•Cutallfirmfruitsandvegetables,cookedmeats,fishand
seafood into pieces no larger than ¾ inch (1.8 cm) to
1inch(2.5cm).Cutallkindsofcheesesintopiecesno
largerthan3/4inch(1.8cm).
•Thisblenderwillnotmashpotatoes,whipeggwhites
or substitute dairy toppings, mix stiff dough or grind
raw meat.
HoT Foods
•OpentheFillerCaptoventsteam.TiltFillerCapawayfromyou.
Keephandsawayfromthecoveropeningtopreventpossibleburns.
•Whenworkingwithhotliquids,removeFillerCapandstartblendingat
alowspeed.Thenmovetoafasterspeed.DONOTaddliquidoverthe4cup
(1 liter) level.
5
FigUre 4
FigUre 5
FigUre 6
FigUre 7
Loading ...
Loading ...
Loading ...