Loading ...
Loading ...
Loading ...
30
1.
Make sure that the power cord is
rmly and correctly connected to the
projector and the outlet.
Turning on the power
2.
Make sure that the POWER indicator is
lighted in steady orange (112). Then
remove the lens cover.
3.
Press the STANDBY/ON button on the
projector or the remote control.
The projection lamp will light up and POWER indicator will begin blinking in
green. When the power is completely on, the indicator will stop blinking and
light in steady green (112).
Power on/off
To display the picture, select an input signal according to the section Selecting an
input signal (
33).
Power on/off
The INITIAL SETTING Menu will be displayed by factory default upon startup.
Once the INITIAL SETTING Menu is set, it will not appear until FACTORY RESET
(94) is executed. If you wish to change the settings, refer to the LANGUAGE
(76) and ALTITUDE (88) menu.
(1) LANGUAGE: Use the ▲/▼/◄/►buttons to
select the desired language and press the
ENTER button of the remote control or the
INPUT button of the projector to execute.
(2) ALTITUDE: Use the ▲/▼ buttons to select
NORMAL for altitude below 1600 m (5250 feet),
otherwise select HIGH and press the ENTER
button of the remote control or the INPUT button
of the projector to execute.
(continued on next page)
POWER indicator
ASPECT
BLANK
ESC MENU
RESET
AUTO
PAGE
DOWN
ON
OFF
FREEZE
UP
ENTER
FOCUS
-
+
ZOOM
-
+
INPUT
INTERACTIVE
MYBUTTON
1 2
PbyP
MAGNIFY
VOLUME
-
+
GEOMETRY PICTURE MUTE
NETWORK
OSD MSG
ASPECT
BLANK
ESC MENU
RESET
AUTO
PAGE
DOWN
ON
OFF
FREEZE
UP
ENTER
FOCUS
-
+
ZOOM
-
+
INPUT
INTERACTIVE
MYBUTTON
1 2
PbyP
MAGNIFY
VOLUME
-
+
GEOMETRY PICTURE MUTE
NETWORK
OSD MSG
STANDBY/ON button
Loading ...
Loading ...
Loading ...