Loading ...
Loading ...
Loading ...
EN
10
2.3 CONNECTING TO THE WATER SUPPLY
1. Check that the water supply pressure is in the following
range: 0,05-0,9MPa. With higher pressures, use a pressure
reducer.
2. Connect the cold water supply hose (blue screw collar)
to the cold water tap with ¾ gas threaded connector, taking
care to tighten firmly to prevent leaks. The water supply
hose must not be kinked or crushed and must not be
changed or cut. Threaded connections must only be tight-
ened by hand.
3. When appliances are supplied with hot water, the intake water temperature must
not exceed 60°C and the hose with red screw collar must be connected to the hot
water supply tap.
Warning!
If the connection is made to new pipelines, or lines which have been out of use
for a long time, allow a considerable amount of water to flow out before connecting
the intake hose. This prevents any sand or other dirt from fouling the filters installed
in the appliance to protect the water intake valves.
The new intake hose supplied with the appliance must be used, and the old water
supply hose must not be used.
2.4 CONNECTING TO THE DRAIN
1. Insert the end of the drain hose into a drain pipe having inside diameter of at least
4 cm, at least 50 to 90 cm above floor level, or connect it securely (using the plastic
fitting on the elbow in the hose) to a sink or bathtub.
2. In all cases, check that the end of the drain hose is securely fixed to prevent the
repulsive force of the water from pushing it out of place.
Warning!
Avoid kinks or restrictions to ensure effective drainage.
Any drain hose extensions must be no more than 1 metre long, must be of the
same diameter and must be free from restrictions of all kinds.
The end of the drain hose must never be submerged in water.
Loading ...
Loading ...
Loading ...