Loading ...
Loading ...
Loading ...
User Manual esatto.house 6 7
• This appliance can be used by children aged from 8
years and above and person with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision
or instruction concerning use of the appliance in
a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children
without supervision. (be applicable for the European
Countries)
• This appliance is not intended for use by persons
(including childern) with reduced physical, sensory
or mental capabilities or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. (be applicable for
other countries except the European Countries )
• Children should be supervised to ensure that they
do not play with the appliance. Children must be
supervised around the unit at all times.
• If the supply cord is damaged, it must be replaced
by the manufacturer,its service agent or similarly
qualied persons in order to avoid a hazard.
• Prior to cleaning or other maintenance, the
appliance must be disconnected from the supply
mains.
• Do not remove any xed covers. Never use this
appliance if it is not working properly, or if it has
been dropped or damaged.
• Do not run cord under carpeting. Do not cover cord
with throw rugs, runners, or similar coverings. Do not
route cord under furniture or appliances. Arrange
cord away from trac area and where it will not be
tripped over.
• Do not operate unit with a damaged cord, plug,
power fuse or circuit breaker. Discard unit or return
to an authorized service facility for examination
and/or repair.
• To reduce the risk of re or electric shock, do not use
this fan with any solid-state speed control device.
• The appliance shall be installed in accordance with
national wiring regulations.
• Contact the authorised service technician for repair
or maintenance of this unit.
• Contact the authorised installer for installation of
this unit.
• Do not cover or obstruct the inlet or outlet grilles.
• Do not use this product for functions other than
those described in this instruction manual.
• Before cleaning, turn o the power and unplug
the unit.
• Disconnect the power if strange sounds, smell, or
smoke comes from it.
• Do not press the buttons on the control panel with
anything other than your ngers.
• Do not remove any xed covers. Never use this
appliance if it is not working properly, or if it has
been dropped or damaged.
• Do not operate or stop the unit by inserting or pulling
out the power cord plug.
• Do not use hazardous chemicals to clean or come
into contact with the unit. Do not use the unit in the
presence of inammable substances or vapour such
as alcohol, insecticides, petrol,etc.
• Always transport your air conditioner in a vertical
position and stand on a stable, level surface
during use.
• Always contact a qualied person to carry out
repairs. If the damaged power supply cord must be
replaced with a new power supply cord obtained
from the product manufacturer and not repaired.
• Hold the plug by the head of the power plug when
taking it out.
• Turn o the product when not in use.
Safety Warnings
IMPORTANT: Please ensure that you read the entire
instructions carefully before beginning the installation
of your air conditioner. Always retain this instruction
user manual.
WARNING: To prevent injury to the user or other people
and property damage, the following instructions must
be followed. Incorrect operation due to ignoring of
instructions may cause damage or serious harm.
• Installation must be performed according to the
installation instructions. Improper installation can
cause water leakage, electrical shock, or re.
• Use only the included accessories and parts, and
specied tools for the installation. Using non-
standard parts can cause water leakage, electrical
shock, re, and injury or property damage.
• Make sure that the outlet you are using is grounded
and has the appropriate voltage. The power cord
is equipped with a three-prong grounding plug to
protect against shock. Voltage information can be
found on the nameplate of the unit.
• Your unit must be used in a properly grounded wall
receptacle. If the wall receptacle you intend to use
is not adequately grounded or protected by a time
delay fuse or circuit breaker (the fuse or circuit
breaker needed is determined by the maximum
current of the unit. The maximum current is
indicated on the nameplate located on unit), have a
qualied electrician install the proper receptacle.
• Install the unit on a at, sturdy surface. Failure to
do so could result in damage or excessive noise and
vibration.
• The unit must be kept free from obstruction to
ensure proper function and to mitigate safety
hazards.
• DO NOT modify the length of the power cord or use
an extension cord to power the unit.
• DO NOT share a single outlet with other electrical
appliances. Improper power supply can cause re
or electrical shock.
• DO NOT install your air conditioner in a wet room
such as a bathroom or laundry room. Too much
exposure to water can cause electrical components
to short circuit.
• DO NOT install the unit in a location that may be
exposed to combustible gas, as this could cause
re.
• The unit has wheels to facilitate moving. Make sure
not to use the wheels on thick carpet or to roll over
objects, as these could cause tipping.
• DO NOT operate a unit that it has been dropped or
damaged.
• The appliance with electric heater shall have at
least 1 meter space to the combustible materials.
• Do not touch the unit with wet or damp hands or
when barefoot.
• If the air conditioner is knocked over during use,
turn o the unit and unplug it from the main power
supply immediately. Visually inspect the unit to
ensure there is no damage. If you suspect the
unit has been damaged, contact a technician or
customer service for assistance.
• In a thunderstorm, the power must be cut o to
avoid damage to the machine due to lightning.
• Your air conditioner should be used in such a way
that it is protected from moisture.
e.g. condensation, splashed water, etc. Do not
place or store your air conditioner where it can fall
or be pulled into water or any other liquid. Unplug
immediately if it occurs.
• All wiring must be performed strictly in accordance
with the wiring diagram located inside of the unit.
• The unit’s circuit board(PCB) is designed with a fuse
to provide overcurrent protection. The specications
of the fuse are printed on the circuit board, such as:
T 3.15A/250V, etc.
Loading ...
Loading ...
Loading ...