Loading ...
Loading ...
Loading ...
23
Questions?
Use this
problem
solver
PROBLEM POSSIBLE CAUSE WHAT TO DO
Suds in the tub (cont.)
For all other models:
•
Pump out water by closing the door until
it locks into place.
• Press the NORMAL WASH button, then
press start.
• Wait for one minute, then press and hold
down the START/CANCEL button for
three seconds. Repeat if necessary.
Too much rinse agent used • Remove any spilled rinse aid.
• Reduce rinse aid setting.
• For soft water, rinse aid may be unnecessary.
Dishes and flatware Improper rack loading • Make sure large dishware does not block
not clean the detergent dispenser or the wash arm.
• Assure silverware is not blocking spray arm.
Filter or spray arms dirty • Clean filters and spray arms according to
instructions on page 20.
Inlet water temperature • Run tap until water is hot, prior to starting
is below 120°F Chef’s Washer cycle.
• Raise the water heater temperature to 120°F.
• Depending on model, use WATER TEMP
HIGH or WATER TEMP SANI option if
suitable for dish load.
Air gap is clogged • Clean the air gap.
Water pressure is • Turn on a faucet. Is water coming out more
temporarily low slowly than usual? If so, wait until pressure
is normal before using your Chef’s Washer.
Water leaks through Opening door during • Pause the cycle before opening the door.
door handle cycle without pausing Follow instructions for interrupting the
machine first cycle for your specific model.
Loading ...
Loading ...
Loading ...