Loading ...
Loading ...
Loading ...
Problem Possible Causes What To Do
“F— and a number
You have a function • Press the
CLEAR/OFF
pad. Put the oven back into
or letter” flash
error code. operation.
in the display
If the function code repeats. • Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• On self-cleaning models, if a function error code
appears during the self-cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, from the locked position. Make sure the latch
is moved to the right as far as it will go. Press the
CLEAR/OFF
pad. Allow the oven to cool for one hour.
Put the oven back into operation.
Display goes blank
A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is turned off • See the
Using the clock and timer
section.
from showing in the display.
Display flashes
Power failure. • Reset the clock.
Unable to get the
Oven control pads were • The
BAKE
and
BROIL HI/LO
pads must be pressed
display to show “SF”
not pressed properly. at the same time and held for 3 seconds.
Power outage,
Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes
it by pressing the
CLEAR/OFF
pad, setting the clock
and resetting any cooking function.
“Burning” or “oily”
This is normal in a new • To speed the process, set a self-clean cycle for a
odor emitting from
oven and will disappear minimum of 3 hours. See the
Using the self-
the vent
in time.
cleaning oven
section.
Strong odor
An odor from the insulation • This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
34
Before You Call For Service…
Troubleshooting Tips
Loading ...
Loading ...
Loading ...