Loading ...
Loading ...
9
is reached, the appliance comes on with the settings used
during the previous period of operation.
Auto-o: with the appliance on, press the timer button
(E). The symbol is displayed together with the time remai-
ning before the appliance goes o.
To set the timer, use the adjustment buttons + and - (B), then
wait a few seconds for the setting to be memorised.
The current settings are displayed again, together with the
symbol indicating that the timer has been set.
When the programmed time is reached, the appliance goes o
automatically. To go back to operation without the timer, press
the timer button (E) twice.
The timer symbol
disappears from the display.
Using the remote control
The functions on the remote control are the same as those on
the appliance control panel.
For a description of the functions, see the “Operation and use”
section on the previous page.
Inserting or replacing the batteries
The remote control is powered by a
CR2032 lithium battery.
To operate the remote control, pull
and remove the plastic strip under
the battery cover.
To replace the batteries, remove
the battery cover by sliding it as
shown in the gure.
When replacing the batteries,
make sure you respect the polarity
(see gure 2).
Replace the cover as shown in the gure.
Old batteries are harmful to the environment and must be
removed and disposed of in compliance with current legi-
slation.
MAINTENANCE
- Always unplug from the mains socket before cleaning.
- During the season when the appliance is in use, clean
the air intake and outlet grilles regularly using a vacuum
cleaner.
- To clean the lter, remove the rear grille by pulling it
outwards (g. 1). Remove the dust lter which retains
impurities in the air drawn in from the room, blow on it
lightly then replace in the appliance.
- Never use abrasive powders or solvents to clean the ap-
pliance.
TROUBLESHOOTING
If the appliance displays “PF” and emits a beep, the tempera-
ture sensor is malfunctioning.
If the problem continues, contact customer services.
If the appliance goes o unexpectedly:
- Make sure it is plugged in correctly to the mains socket.
- Make sure the appliance is standing upright on a at
surface, otherwise the tip over device may be activated.
- Check the temperature and timer settings.
The appliance may have gone o because the set tem-
perature has been reached or the time set on the timer
has elapsed.
TECHNICAL CHARACTERISTICS
Power supply See rating plate
Absorbed power “
en
Use
Fig. 2